Bredel hose lubricant material safety datasheet ... - Watson-Marlow

DR
Page: 2/5
Safety Data Sheet
according to 1907/2006/EC, Article 31
Printing date: 13.04.2010 Revision: 13.04.2010
Trade name: LUBRICANT/COOLANT FOR BREDEL HOSEPUMP 'FOOD GRADE'
NSF Registration No 123204, Category Code H1
· Protective equipment: Wear fully protective suit.
(Contd. of page 1)
6 Accidental release measures
· Person-related safety precautions: Not required.
· Measures for environmental protection: Dilute with plenty of water.
· Measures for cleaning/collecting:
Absorb with liquid-binding material (sand, diatomite, acid binders, universal
binders, sawdust).
Dispose of the material collected according to regulations.
7 Handling and storage
· Handling
· Information for safe handling: No special measures required.
· Information about protection against explosions and fires:
No special measures required.
· Storage
· Requirements to be met by storerooms and receptacles:
Suitable material for receptacles: stainless and carbon steel and plastics.
· Information about storage in one common storage facility: Not required.
· Further information about storage conditions:
This product is hygroscopic.
Protect from humidity and water.
8 Exposure controls and personal protection
· Components with limit values that require monitoring at the workplace:
56-81-5 glycerol
OES Long-term value: 10 mg/m³
57-55-6 propane-1,2-diol
OES Long-term value: 474* 10** mg/m³, 150* ppm
*total (vapour and particulates) **particulates
· Additional information: The lists valid during the making were used as basis.
· Personal protective equipment
· General protective and hygienic measures:
The usual precautionary measures are to be adhered to when handling chemicals.
· Breathing equipment: Not required.
· Protection of hands: Safety gloves recommended.
· Material of gloves
Neoprene
Nitrile rubber, NBR
Fluorocarbon rubber (Viton)
· Penetration time of glove material
The determined penetration times according to EN 374 part III are not performed
under practical conditions. Therefore a maximum wearing time, which corresponds to
50% of the penetration time, is recommended.
(Contd. on page 3)
GB