T-Series Tower Dryers - GRAIN SYSTEMS INC.

T-Series Tower Dryers are designed with the mid-sized to large farm in mind. Capacities range from 1000 BPH to 2400 BPH.
All heat from cooling the grain is recycled and the long retention times result in very efficient dryer operation. A divider hopper
prevents the build-up of fines in the heat section, simplifying maintenance. Self diagnostic controls accurately monitor grain
moisture and temperature. If you need an efficient, quiet, and dependable drying system, the GSI T-Series Tower Dryer is just
what you’re looking for.
IN-LINE BLOWER &
DIVIDER HOPPER
Efficient, quiet, adjustable
pitch blower delivers
high volumes of air at low
horsepower on 1200 BPH
and smaller dryers. The
surrounding divider hopper
prevents particulate build up
in the heat plenum
of the dryer.
OCTAGON BURNER
1200 BPH and smaller
capacities use a fuel efficient
in-line octagon burner to
provide even continuous heat.
MIXED FLOW
INDUSTRIAL BLOWER
Highly efficient, quiet industrial
blower used on all T-Series
dryers, provides years of
trouble free operation.
MAXON NP-LE-AL BURNER
For 1500 BPH and larger
capacities. Maxon fuel
efficient, low nox in-line burner,
with engineered profiling,
provides even continuous
heat. Aluminum extrusion
reduces burner maintenance.
.078"
.0625"
INNER ROOF
Heavy galvanized inner roof and
support provides over 300 bushels
of wet holding in the garner. The
garner is totally sealed to retain
particulate matter.
INVERTERS
BURNER
BLOWER
HEATING
SECTION
COOLING
SECTION
HEAT PLENUM CHAMBER
The heat plenum chamber is
entirely surrounded by a 12-3/4”
grain column. All heated air must
pass through the grain column
resulting in total use of heated
air. Stainless steel, smooth
sidewall construction with .078”
and .0625” perforation diameter
helps retain particulate matter.
Inside:
• Heating section has .078”
perforation sidewalls.
• Cooling section has .0625”
perforation to minimize
particulate matter entering the
cooling section.
Outside:
• Heating section to the Grain
Inverter has .078”
perforation sidewalls.
• Grain Inverter to the cooling
section has .0625” perforation
sidewalls to contain the
particulate matter.
• Cooling section has .078”
perforation sidewalls.
PLATFORMS
Inside/outside platforms, ladders
and cages are standard and provide
access to the dryer.
METERING DRIVE The SCR variable speed
DC motor and the single maintenance
free Cyclo gearbox located in the cooling
chamber provides simple, trouble free
operation of the dryers metering system.
ACCESS DOORS & HATCHES
All areas of the dryer are accessible
through doors and floor hatches for
easy cleaning and maintenance.
SWEEP DISCHARGE
Field proven (patented) Accu-trol
Metering System is self cleaning and
provides positive grain flow.