Outdoor Camera - Philips

Data Sheet
n Pre-assembled units with
housing, camera and lens
included
n Range of colour and
monochrome units
n Choice of high performance
Video 300 cameras
n Varifocal lenses allow Field of
View to be selected on site
n Modern compact design
n Includes wall bracket for
mounting
Introduction
Housing, camera and lens combinations
are frequently used where protection
against the environment is required. In
order to simplify and reduce the
installation process time, the Philips
Outdoor Camera can be used. They are
supplied fully assembled with housing,
camera and a Varifocal lens, which allows
the final Field of View to be selected on
site. This means that installation is simple,
you only have to connect the supply and
video cables, set the focus and the unit is
ready for use. A wall bracket is also
included in the package to enable
mounting of the unit.
Philips
Communication &
Security Systems
Outdoor Camera
Cameras
The Outdoor Cameras are based on the
proven Video 300 series of cameras. These
cameras are available in standard and high
resolution versions, colour and
monochrome and are for use in both
CCIR/PAL and EIA/NTSC areas. The
camera is supplied from a low voltage
supply 11-36Vd.c. or 11-28 Va.c.. As the
complete unit comes fully assembled, no
adjustments are required.
Varifocal Lens
The Varifocal lens supplied is the Passive,
DC auto-iris lens LDH 6748/03. This
lens is chosen because it covers most
applications. By including the lens, the
stock holding for the installer is reduced.
Also, because a Varifocal lens is used, the
Field of View can be selected on site
allowing optimum area coverage.
Housing
The modern compact housing is of a
proven design that provides good
protection against the elements and
hostile environments. It can be used in a
large variety of places such as shops,
offices, petrol stations, industrial
environments, travel and transport areas,
in fact any general indoor and outdoor
use.
LDH 13x0/10; LDH 13x0/60

Outdoor Camera Types
Version PAL/CCIR NTSC/EIA
Outdoor Based on Outdoor Based on
Camera Camera Type Camera Camera Type
Standard Monochrome LDH 1350/10 LDH 0350/00 LDH 1350/60 LDH 0350/60
Standard Monochrome LDH 1370/10 LDH 0370/00 LDH 1370/60 LDH 0370/60
Standard Colour LDH 1360/10 LDH 0360/00 LDH 1360/60 LDH 0360/60
Standard Colour LDH 1380/10 LDH 0380/00 LDH 1380/60 LDH 0380/60
SPECIFICATIONS
Electrical
TV Standard:
/10 version : CCIR, 625 lines interlaced 50 Hz
/60 version : EIA, 525 lines interlaced 60 Hz
CCD sensor : 1/3 inch Inter Line Image Sensor
Electronic iris : control range 46 dB
Sensitivity : Camera dependent
Synchronisation : Mainslock, adjustable phase on
3-phase mains network.
Power supply:
/10 version : 220 V a.c., +/-15%, 50 Hz
/60 version : 115 V a.c., +/-15%, 60 Hz
Lens
Type : F1.4, 3.5-8mm
Field of view (approx) : 78° x 58° - 35° x 26° *
Mechanical
Dimensions
External : 270 x 110 x 89 mm
inc. Sunhood : 270 x 114 x 95.5 mm
Wall stand : Included
Materials
Housing base : aluminium alloy - die-cast
Housing + lens hood : ASA
Window : Metacrylate
Sunhood : white PVC
Seals : EPDM rubber
Colour : light grey/black lens hood
* When lens is set to focal length 4.5 min, the black lens hood
should not be used.
Note:
For detailed Camera & Lens Specifications refer to the respective
Data Sheets.
Philips
Communication &
Security Systems
Environmental
Protection against dust
and water : IEC 529, IP 55
Ambient temperature
Operating : -15° to +40°C
Storage : -40° to +70°C
Wind velocity
Operating : 120 km/hr
Corrosion : IEC 68-2-42 Kc SO 2
: IEC 68-2-43 Kd H 2S
Salt mist : IEC 68-2-52 Kb
Temperature/humidity : IEC 68-2-30 Db
(21 days at 40°C)
Vibration : IEC 68-2-6 Fc (10-58 Hz
0.15 mm amplitude,
58-150 Hz 2g, 3 directions)
Bump : IEC 68-2-29 Eb (1000 bumps,
10 g 16 ms, 3 directions)
Safety : Acc. to IEC 65 and BS 415,
class I
9498 962 28711 96-10 Data subject to change without notice
© 1996 Philips Electronics N.V.
This document is printed on chlorine free produced paper.