Ektasound 235 vintage projector - back home

More documents

Recommendations

Info

Draw off approximately 2 feet of LE~ER. With $he right hand, grasp the leader near the supply reel. Sweep the a film into and through the THREADING CHANNEL, as shown. THREADING CHANNEL LEADER THREADING CHANNEL 3 Insert the end of the leader securely into the s-shapea SLOT in the take-up reel. Rotate the take-up reel clock- h wise to remove any slack. SLOT
# > Your projector can project sound and silent films at 18 or 24 fps (frames-per-second). Films made with KODAK EKTASOUND Movie Cameras are 18 fps. Commercial sound films are usually 24 fps. The projector's dust cover can be installed and the projector operated with the . . * cover in position. Replace the dust cover by guiding its top edge under the top edge of the . projector and pushing in at the bottom. I I forward projection 2 Move the projection control from OFF/THREAD to Adjust the VOLUME CONTROL to the desired listening PROJECT. Rotate the FOCUS WHEEL uxitil the screen level. (For silent movies turn the volume control fully image is sharp. counterclockwise.) Use the FRAME WHEEL to center one complete picture on the screen. Turn the ELEVATION WHEEL, located at the FOCUS WHEEL rear of the projector, to raise or lower the image on the screen. While the projector is running, move the FILM- SPEED CONTROL to the required speed (18 or 24 fps). (Moving the lever to the left changes the speed to 24 fps; to the right changes the speed to 18 fps.) VOLUME CONTROL FRAM EEL FILM-SPEED CONTROL
Page 2 and 3: KODAK EKTASOUND Projector Case To c
Page 4 and 5: If you need help or advice on using
Page 6 and 7: 7"--7 -- Set the PROJECTION CONTROL
Page 10 and 11: ill projd~i luring proj~_--~n you w
Page 12 and 13: operating tips The perforations in
Page 14 and 15: i 1 PROJECTION MIRROR LENS COVER LE
Page 16 and 17: - uo lu!p~oDaa e seq leql wry padpp
Page 18: service facilities Kodrkhrtghm.rknt

Ektasound 235 vintage projector - back home

Create successful ePaper yourself

Delete template?

Save as template?