Geberit Sanitary Compatibility

Items of note
Shallow pans:
Monolith Back to Wall:
Shallow pans with a contact surface smaller than 17 cm will require our
shallow pan connectors 111.847.00.1 for Duofix Frames and 131.105.00.1 for
the Monolith
Universal BTW WC for Monolith Only wall drainage
Monolith
BTW toilets with mounted
P-bend
BTW toilets with open
back and floor
Good BTW WC’s for the Monolith are characterised by:
• Flat contact area to ensure a closed clean connection to
the Monolith
• An pen back and floor to enable floor drainage
connection with P-bend
BTW with a crossbar
• Ceramics with a bar
can only be used
with wall drainage
connection
Bad ceramic
No flat contact
• No closed clean
connection with
Monolith
Monolith – width of WC:
Before choosing your WC pan for the Monolith, please check your drainage connection and pan fixings /
width of pan surface taking the following into consideration:
• The Geberit Monolith sanitary module for wall-hung WC, H114 is sold with bore holes in the glass for
ceramics fastening M12, fastening distance 18cm only
131.031.XX.1
• The Geberit Monolith sanitary module for wall-hung WC, H101 is sold with bore holes in the glass for
ceramics fastening M12, fastening distance holes for both 18cm and 23cm. However, it is important
to note that for the Monolith to look at it’s best the WC must be wide enough to cover the 23cm
bore holes.
131.021.XX.1
• Where the 23cm holes are not acceptable for the H101, an additional piece of glass can be
purchased, with bore holes in the glass for ceramics fastening M12, fastening distance 18cm only
242.383.XX.1
Sanitary – Compatibility July 2012 6