Built-In Natural Gas Grill Installation Guide - Help - Weber

More documents

Recommendations

Info

TYPICAL GAS SUPPLY INSTALLATION (CONT.) ■ Check your local building codes. Gas line piping (continued) ■ Copper tubing must be tin-lined if the gas contains more than 0.3 grams of hydrogen sulfide per 100 cubic feet of gas. ■ Plastic tubing is suitable only for outdoor, underground use. ■ Gas piping in contact with earth, or any other material which may corrode the piping, must be protected against corrosion in an approved manner. ■ Underground piping must have a minimum of 18" cover. Test connections All connections and joints must be thoroughly tested for leaks in accordance with local codes and all listed procedures in the latest edition of ANSI Z223.1/NFPA 54. �DANGER Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for gas leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property. Regulator ■ The regulator should be adequately supported. ■ The regulator must be installed close to the appliance. ■ Each appliance must have a separate regulator. 4 CONNECT GAS SUPPLY TO REGULATOR Hard pipe the gas supply to the inlet of the regulator. Make a "T" fitting from your hard pipping if you plan on adding additional Vieluxe ® gas appliances. Refer to “Typical Gas Supply Installation”. Connect the corrugated gas line to the regulator. Figure 1. Figure 2 shows the gas line and regulator assembled. Hard pipe the gas supply to the regulator. Figure 3. Figure 1 Gas supply to manifold Figure 2 Gas supply to manifold Figure 3 Regulator Regulator Regulator Hard piped gas supply Gas supply to manifold Note: Leave an access in the “island” structure for gas supply and regulator service not inside the grill structure. Vieluxe ® has a gas line and regulator access door available from your dealer or call Vieluxe Customer Service at 1-866-VIELUXE. (Vieluxe ® part number 36311).
BUILT-IN GRILL INSTALLATION � CAUTION: Use two people to lift and install the Vieluxe ® grill. 1) Lift the grill out of the packaging. 2) Make sure that the Adjustable Feet are fully extended and secure before setting grill in place. 3) Push the grill into the “island” structure making sure that the grill frame does not rest on the top of the “island” structure. Make sure the grill is resting on it’s Adjustable Feet only. 4) Guide the gas line through the access hole in the grill frame while installing the grill. Grill Frame Adjustable Feet Foot fully extended and secured Gas Line Foot not fully extended 5 5) Lower the grill by adjusting the feet until the grill frame is resting firmly on the "island" countertop. Note: Make sure that the grill is level on the "island" countertop. Grill Frame "Island" Structure Countertop 6) Once the grill is level with the top of the “island” structure, apply a bead of silcon sealant around the perimeter and front sides of the grill that is in contact with the “island” structure. This will prevent moisture seepage. The sealant you use must have a temperature rating above 120° F. Silicon Sealant
Page 1 and 2: Built-In Natural Gas Grill Installa
Page 3: TYPICAL GAS SUPPLY INSTALLATION WE
Page 7 and 8: ASSEMBLY SUPPLIES NEEDED Note: Remo
Page 9 and 10: INSTALL SMOKER Parts required: smok
Page 11: Slide the bottom tray into the moun

Built-In Natural Gas Grill Installation Guide - Help - Weber

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?