SIGNALLING - Urmet

More documents

Recommendations

Info

TRANSFORMERS/SERIES INSTALLATION UNITS Bell transformers Safety transformers (up to 18 VA) 48 GT 1975 GT 36 AP Safety transformers (up to 25 VA) GT 1973 GT 54 AP Safety transformers (up to 63 VA) GT 1990 GT 90 AP Description Installation in electrical distributor/flat distributor, tested according to EN61558 Short-circuit resistance through PTC, suitable for continuous load Meets the most stringent environmental requirements Certified by VDE and KEMA, identified by ENEC mark for use throughout Europe Technical data Primary: 230–240 V~ (50 Hz) 90 x 36 x 55 mm (corresponds to 2 installation modules) Note Higher output voltage at low loads or no load! Following a short circuit, start-up is to be performed by briefly disconnecting the primary side from the mains Accessories for surface-mount installation set Incl. two covering caps for IP 20 Incl. clamping rail and material for surface-mount installation Model Order no. Description Technical data GT 1965 14102 Safety transformer 8 V~ (2.0 A) GT 1975 14101 Safety transformer 12 V~ (1.5 A) GT 36 AP 14936 Surface-mount installation set Description Installation in electrical distributor/flat distributor Suitable for continuous load, short-circuit resistance through PTC Meets the most stringent environmental requirements Tested according to EN61558 Certified by VDE and KEMA, identified by ENEC mark for use throughout Europe Technical data Primary: 230 V~ (50 Hz) 90 x 54 x 55 mm (corresponds to 3 installation modules) Description Installation in electrical distributor/flat distributor Short-circuit resistance through PTC Suitable for continuous load Meets the most stringent environmental requirements Tested according to EN 61558 Certified by VDE and KEMA, identified by ENEC mark for use throughout Europe Technical data Primary: 230 V~ (50 Hz) 90 x 90 x 55 mm (corresponds to 5 installation modules) Note Higher output voltage at low loads or no load! Following a short circuit, start-up is to be performed by briefly disconnecting the primary side from the mains Accessories for surface-mount installation set Incl. two covering caps for IP 20 Incl. clamping rail and material for surface-mount installation Model Order no. Description Technical data GT 1973 14034 Safety transformer 8/12 V~ (2.0/2.0 A) GT 54 AP 14954 Surface-mount installation set Note Higher output voltage at low loads or no load! The secondary windings with cable links are to be connected in series or parallel (see type label) depending on the selected output voltage Following a short circuit, start-up is to be performed by briefly disconnecting the primary side from the mains Accessories for surface-mount installation set Incl. two covering caps for IP 20 Incl. clamping rail and material for surface-mount installation Model Order no. Description Technical data GT 1980 14140 Safety transformer 12/16/24/32 V~ (3.3/2.5/1.6/1.2 A) GT 1990 14160 Safety transformer 12/24 V~ (5.2/2.6 A) GT 90 AP 14990 Surface-mount installation set
TRANSFORMERS/SERIES INSTALLATION UNITS Staircase light time switches The benefits for you Staircase light time switches High load capacity Switching capacity up to 3000 W Glow lamp current up to 150 mA Description Electronic control Time setting: Continuously variable up to 12 min For 3/4-lead circuits (automatic detection) 3/4-lead circuits delayed switching capacity/switching time extension (3-lead circuit for unit replacement in existing installations only) Installation in electrical distributor (standard rail) Switch-off advance warning in accordance with DIN18015-2, 1996-08 (approx. 30 seconds before time expiry; flickers several times) Switch-off advance warning can be disabled Adjustable continuous light function on the light switch or on the staircase light time switch Contact switch in the zero point to protect contacts and lamps Separate movement detector input Maximum convenience Switch-off advance warning in accordance with DIN Continuous light controlled via light switch Technical data Operating voltage (230 V~/50 Hz) Contact load: 16 A, (one normally open contact) Control voltage: 8–230 V~/= and 230 V~ Glow lamp current max. 150 mA Max. load capacity: Filament bulbs 3000 W, energy-saving bulbs 700 W, fluorescent tubes 500/1000 W (compensated/uncompensated). We recommend using filament bulbs for staircase illumination! Temperature range -10°C to +40°C 82 x 18 x 55 mm (1 module width) Staircase light controlled via light switch (230 V~): - Press light switch repeatedly for < 1 sec: Extension of the lighting period by set time (additive) - Press light switch for switch for > 1 sec: Continuous "On"/Continuous "Off" (Auto "Off" after 1 hr) Model Order no. Description Technical data TA 220c 94022 Staircase light time switch Simple installation Automatic detection of the 3/4-lead circuit Installation height suitable for flat distributor Staircase light time switches Function overview Staircase light time switches Installation replacement of previous models TA 22/TA 23: The configuration of the terminals is to be changed according to the installation instructions. When replacing units and changing the on-site installation, ensure the wires have been labelled correctly in terms of colour. 49
Page 1 and 2: SIGNALLING 2008 / 2009
Page 3 and 4: � CONTENT 3 � CHIMES Radio Chim
Page 5 and 6: choosy CHIMES Radio chimes 6 Electr
Page 7 and 8: RADIO CHIMES Product overview MISTR
Page 9 and 10: Model Order no. Description Technic
Page 11 and 12: The deluxe electronic chime with a
Page 13 and 14: Description Dual tone Electromechan
Page 15 and 16: The 230V chime without the need for
Page 17 and 18: unmistakeable SOUND DEVICES: BELLS,
Page 19 and 20: Universal-use sounder with very hig
Page 21 and 22: Product features White plastic hous
Page 23 and 24: Sturdy waterproof bell in signal co
Page 25 and 26: Compact horn with high volume and a
Page 27 and 28: expressive OPTICAL AND ACOUSTIC SIG
Page 29 and 30: OPTICAL AND ACOUSTIC SIGNALLING DEV
Page 35 and 36: Compact, modular warning posts with
Page 39 and 40: Product features Vertical mounting
Page 43 and 44: High-grade xenon flashing beacon wi
Page 45 and 46: powerful TRANSFORMERS/SERIES INSTAL
Page 47: Description With single-pole mains
Page 51 and 52: perfect in form BELL BUTTONS & CONT
Page 53 and 54: Description Flush-mounted installat
Page 55 and 56: Description Surface-mounted install
Page 57 and 58: Description Surface-mounted install
Page 59 and 60: Description Prestigious stainless s
Page 61 and 62: CONTACTS FOR PROTECTIVE EXTRA-LOW V
Page 63 and 64: Innovative red-illuminated bell but
Page 65 and 66: Product features High-grade stainle
Page 67 and 68: eliable ACCESS CONTROLS & ACCESSORI
Page 69 and 70: Description Compact door opener wit
Page 71 and 72: NOTES 71
Page 73 and 74: MODEL LIST 73 MODEL LIST
Page 75 and 76: MODEL LIST Order no. Type Type Desc
Page 83: SIGNALLING 2008 / 2009 Internationa

SIGNALLING - Urmet

Create successful ePaper yourself

Delete template?

Save as template?