You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Audio</strong><br />
SIRUS TXR-1000<br />
DIGITAL AUDIO/MIDI INTERFACE<br />
CODE 18<strong>06</strong><br />
The TXR-1000 USB/<strong>Audio</strong>/Midi Interface which offers all kinds of features<br />
for recording<br />
and monitoring.<br />
Whether single-channel- recording (microphone signal, other playback-signal,<br />
etc.) or hum-signal, TXR-1000 which offers its wide range<br />
of suitable inputs and outputs almost any type of signal interconnection,<br />
which is estimated in the everyday-recording.<br />
The interface is used by all current sequences-programs automatically.<br />
Select it using the default settings of your programs to the TXR, and<br />
Properties:<br />
- 2 x Mic/line-In combined connector female -symmetric XLR76,3 mm jack<br />
switchable-Mic./Line level input at the front panel with gain control and clip<br />
LED<br />
- 2 x RCA input jack for external effects devices<br />
- 2 x symmetric 6,3 mm jack output<br />
- 2 x 6,3 mm jack output with preamp - here you can small passive speakers be<br />
connected. Through this source is unnecessary for small setups a separate<br />
power amp or active speakers.<br />
- SPIF RCA input / output jack<br />
- Midi input / output jack<br />
- USB connector<br />
- On/Off for phantom<br />
- 12 V/DC input<br />
- Input/output Level control<br />
- Switch for USB operating mode (16/24-bit resolution)<br />
- Regulator for mix-used Input and / or output signal<br />
Alternatively, the ratio can be mixed (useful for directly monitoring)<br />
- Switch for Mono-/Stereo operating<br />
- +48V switchable phantom<br />
- Midi In/ Out - Status LEDs<br />
- Play/Record - Status LEDs<br />
- 6,3 mm jack Headphone output<br />
- 48 kHz/96 kHz able<br />
Incl.<br />
Software<br />
USB<br />
Powered<br />
already, all input and output signals are routed through the device.<br />
Another advantage is the USB operation.<br />
The device can be either by USB or power supply.<br />
The latter is only necessary if the built-in amplifier is used in stages.<br />
This allows the two outputs on the designated device passive speakers<br />
to be close to no power amplifier / loudspeaker signals actively<br />
listen to.<br />
The built-MIDI interface allows connection of midi-enabled devices,<br />
for example, controller keyboards and control software<br />
48 V<br />
Phantom<br />
Line<br />
Input<br />
479