Technical Data Sheet - Lindberg & Lund AS
Technical Data Sheet - Lindberg & Lund AS
Technical Data Sheet - Lindberg & Lund AS
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Technical</strong> <strong>Data</strong> <strong>Sheet</strong><br />
Westech WT-PS13 (can) is formulated as a non-methylene chloride,<br />
solvent-based, polystyrene adhesive for industrial use.<br />
<strong>Technical</strong> <strong>Data</strong>:<br />
• VOC range:
Application:<br />
Shaking is recommended before use. Optimum temperature range for application is 60°F to 80°F.<br />
Both adhesive and substrates should be in this range for best performance. Lower temperatures<br />
may affect sprayability. Always maintain can in an upright position and hold parallel to<br />
substrate. Coat in smooth motions with little or no overlap. Coverage should vary according to<br />
materials being bonded. Spray both surfaces to be bonded; one surface vertically and the other<br />
surface horizontally. Allow adhesive to tack up until no adhesive transfers to finger when<br />
touched (approximately 2 to 3 minutes). Align surfaces properly and press together with firm<br />
pressure. It is recommended that a roller be used to apply uniform pressure over the entire<br />
surface area to achieve maximum bonding strength.<br />
Clean-up:<br />
Tips should be cleaned with WT-AR Adhesive Remover after use. The use of WT-AR after each<br />
spray will prevent clogging problems. At the end of spray operations, the tip should be wiped<br />
with adhesive remover. The use of gloves and eye protection is recommended during any spray<br />
or clean up operations.<br />
Safety Recommendations:<br />
Vapors may be harmful to health. Use only in well-ventilated areas or use respiratory protection.<br />
The product MSDS should be read and understood before use. Eye protection is required. This<br />
product is flammable. Keep away from fire or flame. Keep away from children.<br />
Liability & Warranty Notice:<br />
Westech Aerosol Corporation shall not be held liable for any damage or loss arising from<br />
the use, purchase or any inability to use this product, or for any indirect, incidental, special or<br />
consequential damages. No warranties, expressed or implied, are made, including<br />
merchantability and/or fitness for a particular purpose. If the user suspects a defective product, a<br />
sample may be submitted to Westech for testing. If the sample proves defective, the remedies<br />
include either product replacement or reimbursement of paid purchase price. No one has the<br />
authority to modify the limitations or obligations of this warranty.<br />
5405 Constance Drive SW • Port Orchard, WA 98367<br />
Tel: 360-674-2051 • Fax: 360-674-2053<br />
Toll Free: 877-674-2010<br />
www.ok2spray.com