DIVINYCELL H Grade Foam - Fiberglass Supply

Divinycell International, Inc.
MATERIAL SAFETY DATA SHRET
SECTION 1
PRODUCT IDENTIFICATION
Product Name:
DIVINYCELL “H” Grade Foam
H30, H45, H60, H80, H100, H130
Manufacturer’s Name:
Divinycell International, Inc.
315 Seahawk Drive
DeSoto, Texas 75115
Emergency Telephone# (800) 852-4835
Information Telephone # (214) 228-7600
Last Revision Date: 1/7/94 Rev. C
This product is manufactured without CFC’s or any other products which act in
an ozone depletion manner.
SECTION II
Components
Not Applicable
SECTION III
HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
PHYSICAL AND CHEMICAL CHARACTERISTICS
Boiling Point
Vapor Pressure (mm Hg)
Vapor Density (Air-i)
Solubility in Water
Appearance and Odor
Specific Gravity (H20 -1)
Melting Point
Evaporation Race
SECTION IV
N/A
N/A
N/A
N/A
Foam slabs or sheets/no odor
N/A
N/A
N/A
FIRE AND EXPLOSION HAZARD DATA
Flash Point (Method Used)
Flammable Limits
Extinguishing Media
Special Fire Fighting Procedures
Unusual Fire and Explosion Hazards
Oxygen Index less than 3096 (ASTM D2863) Self
Extinguishing (ASTM 1692)
Direct flame only
Water, Dry Chemical
None
None
1

SECTION V
stability
incompatibility
Hazardous decomposition
or by-product
REACTIVITY DATA
Can be used at temperatures 1700- 1800°F.
thermally stable at 2100 F.
Avoid exposure to temperatures above 300°F.
HC1, CO, CO2, HCN, NOx during fire conditions
Hazardous Polymerization
conditions to avoid Will not occur N/A
SECTION VI
Route of entry
HEALTH HAZARD DATA
Inhalation
Acute and Chronic
Hazards
Carcinogenicity
Signs and symptoms of
Exposure
Traces of HC1 during machining. Avoid inhalation of dust or smoke.
N/A
Shortness of breath, dizziness
Medical conditions generally
aggravated by exposure Pneumonistis
Emergency/First Aid
SECTION VII
Spills
Waste Disposal
Precautions for handling
and storing
Remove to fresh air-consult physician if shortness of breath
continues.
PRECAUTION FOR SAFE HANDLING AND USE
None
Landfill - consult local regulations
Avoid storing in areas where temperature may exceed 280° degrees
Fahrenheit.
Other precautions
Abrasive dust may irritate skin
2

SECTION VIII
CONTROL MEASURES
Respiratory Protection
Ventilation
Protective gloves
Eye protection
Other Protective Clothing
or equipment
Work/Hygienic Practices
Dust mask during machining, sawing and sanding
Local exhaust - fans or vacuum
None
Dust protection
None
None
Divinycell International, Inc.
DIVINYCELL H SERIES FOAM
THE INFORMATION CONTAINED HEREIN IS BASED ON DATA CONSIDERED TO BE
ACCURATE WHILE THE INFORMATION IS BELIEVED TO BE RELIABLE NO
WARRANTY IS EXPRESSED OR IMPLIED REGARDING THE ACCURACY OF THIS
DATA OR THE RESULTS TO BE OBTAINED FROM THE USE THEREOF. SINCE THE
USE OF THIS INFORMATION AND THE CONDITIONS AND USE OF THIS PRODUCT
ARE CONTROLLED BY THE USER, IT IS THE USER’S OBLIGATION TO DETERMINE
THE CONDITIONS FOR SAFE USE OF THIS PRODUCT.
Material Safety Data Sheet may be used to comply with OSHA’s Hazard Communication
Standard, 29 CFR 1910.1200. Standard must be consulted for specific requirements
3