r35 gt-r gt1000 full turbine kit installation manual - SpeedForSale.com
r35 gt-r gt1000 full turbine kit installation manual - SpeedForSale.com
r35 gt-r gt1000 full turbine kit installation manual - SpeedForSale.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Temporarily install the turbochargers to the exhaust<br />
manifolds. Adjust the angle of the center housing and<br />
<strong>com</strong>pressor housing. (Dia. 2-4-7, 2-4-8)<br />
<br />
NOTE <br />
Adjust the positions of the Chamber Pipe, Oil Pipe,<br />
and Water Pipe here so <strong>installation</strong> of these pipes will<br />
be easier.<br />
Make sure there is sufficient clearance between the<br />
pipes and the vehicle’s body. Adjust the pipe<br />
positions if necessary.<br />
If it is necessary to change the <strong>installation</strong> angle of<br />
the turbocharger(s), follow the procedure (5) and (6) to<br />
change the angle.<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
<br />
Remove the Turbocharger and install the cup ring as follows:<br />
(Dia. 2-4-9, 2-4-10)<br />
1. Tighten to 16 ±1Nm.<br />
2. Lightly hit both sides of the cup ring with a brass bar.<br />
3. Tighten to 16 ±1Nm.<br />
4. Lightly hit both sides of the cup ring.<br />
5. Tighten to 16 ±1Nm.<br />
<br />
<br />
<br />
<br />
<br />
<br />
Dia.2-4-10<br />
<br />
Tighten the bolts on the <strong>com</strong>pressor housing to 13±1Nm.<br />
There are 6 bolts on each side of the <strong>com</strong>pressor housing.<br />
(Dia. 2-4-11)<br />
<br />
<br />
<br />
<br />
<br />
<br />
Dia.2-4-7<br />
Dia.2-4-8<br />
No Contact!<br />
Dia.2-4-9<br />
Dia.2-4-11<br />
- 35 -