Electric chain hoists LIFTKET - liftket.de

Section 02: clutch – brake
DC- brake with counterscrews (6 holes drilled through the magnetic coil
no more available in new hoists, only produced for spare part supply
slow speed motor of version 9.1
clutch for slow speed motor
(see on page 28)
*For orders that include rotor unit or magnetic coil please provide power supply data such as voltage, frequency etc.
No. 1 Brake - clutch section complete
No. 2 Clutch disc consists from: clutch disc, feather key, clutch lining
No. 3 Rotor section complete* consists from: rotor, hollow shaft, 2 pcs. bush
bearings, parallel pins, axial roller bearing, roller bearing, shim rings
No. 4 Motor cover complete consists from: motor cover, 4 pcs. hexagon socket
cap screws, roller bearing, retaining ring, 3 holding screws, 3 clutch socket, 3
counterscrews, 3 connecting screws
No. 5 Brake hub / brake disc complete consists from: brake hub, brake disc, 2
pcs. brake lining, 3 pcs. balls, feather key for Brake hub
No. 6 Pressure disc
No. 7 Clutch spring
No. 8 Spring plate complete consists from: spring plate with welded hexagon nut,
hexagon nut
No. 9 Motor pinion shaft (if pinion shaft only is needed please go to spare part list
AA lifting gear section 04 part No. 1)
No. 10 Magnetic coil complete* consists from: Magnetic coil, 3 pcs. brake
pressure springs, anchor plate
No. 11 Clutch section for slow speed motor complete consists from: Pos. 12 - 17
(look at page 27)
No. 12 Spring plate complete consists from: spring plate with welded hexagon nut,
hexagon nut
No. 13 Clutch spring
No. 14 Pressure pin
No. 15 Clutch hub with feather key and clutch lining
No. 16 Motor shaft
No. 17 Rotor section complete consists from: rotor, 2 hollow shafts, 2 bush
bearings
15