Electronics Interface units and PLC solutions

More documents

Recommendations

Info

Introduction Interface units RSSD interface units for pre-assembled leads with SUB-D plug connectors to IEC 807-2/DIN 41652 RS ELCO interface units for pre-assembled leads with hermaphrodite plug connector system A Passive interface unit for 9 … 50 signals for adapting preassembled leads with SUB-D plug to IEC 807-2/DIN 41652 to screw or tension clamp connection systems. The components are supplied with either female or male connectors. A spacer block between plug connector and PCB cushions the mechanical forces occurring between the connected cables. RSSD interface units can be supplied with an earth terminal for shielded leads as an optional feature. An additional test point simplifies testing and measuring during initial setup and when servicing the system. Weidmuller’s passive interface units are used for adapting hermaphrodite ELCO multi-pole connectors, for input and output, to screw terminal systems. The hermaphrodite contact is a fork-type contact that is identical in design on both sides of the connection, but with one fork turned through 90° to engage with the other. RS VERT interface units as voltage distributor RS RJ45 interface units for connecting data lines Passive interface units for the distribution of dc supply voltage. These interface units are available in three designs for distribution to 8, 16 and 72 connections, for positive and negative voltages in each case: • 8x and 16x distributor just 45 mm wide overall, 72x distributor 100 mm wide • Fed by two connection elements for positive and negative voltages in each case • Fits on TS32/35 mounting rails RS VERT voltage distributors can also be used in small enclosures and provide clearly organised distribution. The RS RJ45 interface module offers the user a convenient, easy-to-use interface for connecting modems, notebooks and other office equipment in the electrical cabinet. The module converts the standard RJ45 connection to a screw terminal system or acts as a coupling to connect data leads by means of two RJ45 sockets. For data transmission rates of up to 100 Mbps, it is advisable to connect one end of the shield of the data cable to a protective earth. The interface modules can be fitted on TS 32/35 mounting rails. A.3
Interface units IEC 603-1 - DIN 41651 (Ribbon connector) Interface units Interface units IEC 603-1 DIN 41651 (Ribbon connector) • Pin connector with locking feature to IEC 603-1 • Tension clamp or screw connection system • 45 or 87 mm wide • For mounting on TS32, TS35 x 7.5 and TS35 x 15 RSF Z/ IEC 603-1 RSF S 45 mm/ IEC 603-1 A 71.1 67.6 63.6 p 1 3 5 7 9 11 65.5 1 p 2 4 6 8 10 87 45 Technical data Connection data Connection on process side Stripping length Connection on control side 03-1/ DIN 41651 Connection data PCB terminal LM2NZF s side 7.0 mm ing length Plug-in connector to IEC 603-1/ DIN 41651 Connection data PCB terminal LPK 2 H side 7.0 mm ing length Plug-in connector to IEC 603-1/ DIN 41651 Rated data Conversion PCB/plug connector Rated voltage DC Rated current per connection Test voltage (~eff) Test torque Storage temperature Ambient temperature (operational) Terminal rail Rated data 1:1 ersion PCB/plug connector 60 V AC/ 75 V DC 1 A ed current per connection 1.0 kV oltage (~eff) Test torque -40 °C…+70 °C ure 0 °C…+55 °C ature (operational) Terminal rail Rated data 1:1 ersion PCB/plug connector 60 V AC/ 75 V DC 1 A ed current per connection 1.0 kV oltage (~eff) 0.40 Nm rque -40 °C…+70 °C ure 0 °C…+55 °C ature (operational) TS 35 al rail Insulation coordination (EN 50178) Surge category Pollution severity Approvals Standards Insulation coordination (EN 50178) III e category 2 llution severity Approvals EN 50178 Insulation coordination (EN 50178) III e category 2 llution severity Approvals EN 50178 Clamping range (rating- / min. / max.) mm 2 Length x width x height mm Note 1.5 / 0.5 / 2.5 87.0 x — x 64.0 1.5 / 0.5 / 2.5 45.0 x — x 65.5 Ordering data 10-pole 14-pole 16-pole 20-pole 26-pole 34-pole 40-pole 50-pole 60-pole 64-pole Type Width Order No. RS F10 Z 50.0 mm 8537190000 RS F14 Z 50.0 mm 8537200000 RS F20 Z 65.0 mm 8537110000 RS F26 Z 80.0 mm 8537180000 RS F34 Z 110.0 mm 8537130000 RS F40 Z 115.0 mm 8537140000 RS F50 Z 145.0 mm 8537150000 Type Width Order No. RS F10 LPK 2H/12 49.0 mm 8155610000 RS F14 LPK 2H/16 56.0 mm 8258980000 RS F16 LPK 2H/18 64.0 mm 8265540000 RS F20 LPK 2H/22 71.0 mm 8155600000 RS F26 LPK 2H/28 86.0 mm 8213470000 RS F34 LPK 2H/36 106.0 mm 8155590000 RS F40 LPK 2H/42 121.0 mm 8155580000 RS F50 LPK 2H/52 150.3 mm 8155570000 RS F60 LPK 2H/62 180.0 mm 8259000000 RS F64 LPK 2H/66 186.0 mm 8155550000 Note Accessories Note A.4
Page 1 and 2: C A T A L O G U E 4.5 2010|2011 Ele
Page 3 and 4: Overview of products Electronics -
Page 5: Introduction Interface units Weidm
Page 9 and 10: Interface units IEC 807-2 - DIN 416
Page 11 and 12: Supply voltage distributor modules
Page 13 and 14: Interface units with RJ45 plug conn
Page 15 and 16: Interface units A A.12
Page 17 and 18: Introduction Card holders The advan
Page 19 and 20: Card holders 19’’ Euro format S
Page 29 and 30: Card holders B B.14
Page 31 and 32: Universal precabling for PLCs PLC I
Page 33 and 34: Universal precabling for PLCs PLC I
Page 35 and 36: Selection guide PLC Interfaces H-,
Page 49 and 50: Module overview - Direct inputs/out
Page 51 and 52: Direct inputs/outputs for digital c
Page 57 and 58:
Direct inputs/outputs for digital c
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Module overview - Opto-decoupled in
Page 69 and 70:
Opto-decoupled inputs for digital c
Page 71 and 72:
Module overview - Relay outputs for
Page 73 and 74:
Relay outputs for digital cards PLC
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Module overview - Analogue input/ou
Page 85 and 86:
Input / output for analogue cards P
Page 87 and 88:
Input / output for analogue cards P
Page 89 and 90:
Byte precabling system Byte precabl
Page 91 and 92:
Selection guide Byte precabling sol
Page 93 and 94:
Selection guide Byte precabling sol
Page 95 and 96:
PLC front adapter for SIEMENS S7 By
Page 97 and 98:
PLC input/output module passive Byt
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
PLC input/output module active Byte
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Adaptor and solution for MICROSERIE
Page 111 and 112:
Voltage [V] Output current [A] Rela
Page 113 and 114:
Relays - MICROSERIES Byte precablin
Page 115 and 116:
Optos - MICROSERIES Byte precabling
Page 117 and 118:
Optos - MICROSERIES Byte precabling
Page 119 and 120:
Universal cables Byte precabling so
Page 121 and 122:
Accessories Byte precabling solutio
Page 123 and 124:
Byte precabling solution D D.36
Page 125 and 126:
Customer specific solutions Weidmü
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Type Order No. Page Type Order No.
Page 133 and 134:
Order No. Type Page Order No. Type
Page 135 and 136:
Order No. Type Page Index 944804000
Page 137 and 138:
Index X X.8
Page 139 and 140:
Addresses worldwide Index AE United
Page 141:
Index We cannot guarantee that ther
show all

Electronics Interface units and PLC solutions

Create successful ePaper yourself

Delete template?

Save as template?