iTX_Manual (English).pdf - Usmra.com

More documents

Recommendations

Info

BOTTOM FRONT Sensor Openings Sampling Pump Contact Display PPM PPM PPM Audible Alarm Unmarked Key %VOL PPM LEL/CH4 Unmarked Key Visual Alarm Visual Alarm i-Button ® Contact On/Off Mode Key Enter/Backlight Key Charger/ Datalink Connector External Alarm Jack Battery Cover BACK SIDE 7
INSTRUMENT OPERATION TURNING THE iTX ON AND OFF New Sensors Installed 8 Revision 1.0 CO2 NH3 CO O2 H2S E to Continue CO SO2 H2S 10 O2 CL2 LEL CO SO2 H2S O 0.0 0 O2 Cl2 LEL 20.9 0.0 0 To turn the iTX on, press and hold until the instrument emits a short beep and the iTX welcome screen appears on the display. The current revision of instrument operating software is shown below the instrument model name. After the iTX warm-up screen, the display will identify any new sensors installed which have not been calibrated in the instrument. If this screen appears, the instrument must be calibrated prior to further use. If the system clock has not been set, you will be prompted to do so. Prior to entering the normal operating mode, the iTX display will show the type of each sensor installed in the instrument along with a brief countdown timer until normal gas readings appear. To turn the iTX off, press and hold at any time during operation until the instrument display shows RELEASE. After releasing the instrument’s display will blank and all operation will cease. GAS READING MODE In the Gas Reading Mode the iTX will show the type of each sensor currently installed with the corresponding gas concentration shown directly underneath it. A battery status indicator is shown in the center of the display. As the instrument battery life is reduced, the shaded area of the battery indicator will clear until the instrument reaches the low battery condition. With 15 minutes of battery life left, a low battery condition occurs. The instrument will make a periodic tone alerting the user that the battery needs charged or replaced. If a preset gas alarm level is exceeded for either low, high, STEL or TWA, the iTX will activate audible and visual alarms and the corresponding gas display will flash.
Page 1 and 2: Multi-Gas Monitor Instruction Manua
Page 3 and 4: Multi-Gas Monitor 2 TABLE OF CONTEN
Page 5 and 6: WARNINGS AND CAUTIONARY STATEMENTS
Page 7: UNPACKING THE INSTRUMENT The shippi
Page 11 and 12: PEAK READINGS CO SO2 H2S 38 10.6 13
Page 13 and 14: TIME/DATE/TEMPERATURE 72F 14 March
Page 15 and 16: In General: • Pressing or will st
Page 17 and 18: QUICK CALIBRATION 16 Quick Calibrat
Page 19 and 20: Non-Latching Alarm Configuration E
Page 21 and 22: Next Calibration Dates 30 Days E to
Page 23 and 24: Active Site None E to Change Allow
Page 25 and 26: %VOL PM PM PM PM LEL/CH4 STANDARD C
Page 27 and 28: PPM %VOL PPM PPM PPM LEL/CH4 The iS
Page 29 and 30: CHANGING GAS SENSORS TOXIC 3 iTX se
Page 31 and 32: MEASURING RANGES & RESOLUTION: Rang
Page 35 and 36: WARRANTY Industrial Scientific Corp
Page 38: P/N 1709-5753 Rev 6 Printed 0709-10

iTX_Manual (English).pdf - Usmra.com

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?