FRIALEN® Safety Fittings for House Service and Supply ... - Friatec
FRIALEN® Safety Fittings for House Service and Supply ... - Friatec
FRIALEN® Safety Fittings for House Service and Supply ... - Friatec
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Be<strong>for</strong>e starting the fusion process, check again based on the markings<br />
whether the position of the pipe insertion end in the FRIALEN ® <strong>Safety</strong> Fitting<br />
has shifted (correct, if required).<br />
WARNING!<br />
A non-tension-free or shifted joint<br />
may result in an impermissible<br />
melt flow <strong>and</strong> a defective joint<br />
during fusion (see Fig. 8).<br />
4.8 Carrying out fusion<br />
WARNING!<br />
Only use fusion units which have been approved by the manufacturer<br />
with regard to their function <strong>for</strong> the processing of FRIALEN ® <strong>Safety</strong><br />
<strong>Fittings</strong>. See DVS 2207-1.<br />
The fusion parameters are contained<br />
in the main barcode affixed to the<br />
FRIALEN ® <strong>Safety</strong> Fitting. When<br />
using fully automatic fusion units<br />
(e.g. FRIAMAT ® ), the parameters are<br />
entered into the fusion unit using the<br />
reader.<br />
Fig. 8<br />
The subordinated barcode contains Fig. 9<br />
the data <strong>for</strong> component traceability<br />
(see in<strong>for</strong>mation 2). This barcode is only to be read if the component traceability<br />
function is to be used. This requires suitable fusion units.<br />
The fusable pipe series are listed in the SDR labelling on the label.<br />
The fusion units automatically monitor the fusion process <strong>and</strong> control the<br />
supplied energy in determined limits.<br />
01.09.2010<br />
11 Update
Change language