2320 MHz - Ok1dfc.com
2320 MHz - Ok1dfc.com
2320 MHz - Ok1dfc.com
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Hello Dear Ham radio EME Friend,<br />
Thanks very much for interest and using of septum feed<br />
for ham radio circular polarization traffic.<br />
The feed is pre tuned. See in diagram. Pre-tuning was<br />
done in free space and after installation feed inside dish<br />
must be tuned again minimum SWR depend your dish.<br />
For tuning you will use screws on opposite side feed.<br />
Where is TX and RX please see below.<br />
If you have any further question send me please your e-<br />
mail.<br />
I wish all the best and many nice QSOs with the feed.<br />
Instruction manual<br />
Septum feed<br />
<strong>2320</strong> <strong>MHz</strong><br />
Best regards Zdenek OK1DFC<br />
No <strong>com</strong>mercial product!<br />
HAM RADIO ONLY!<br />
SAMEK Zdeněk – OK1DFC<br />
www.qsl.net/ok1dfc - ok1dfc@tesmail.cz<br />
Libeň 156<br />
25241 LIBEŇ – Dolní Břežany<br />
CZECH REPUBLIC<br />
© OK1DFC 10.February 2003
dB<br />
-5<br />
-10<br />
-15<br />
-20<br />
-25<br />
-30<br />
-35<br />
Return Loss - septum feed 13cm TX<br />
M1: -24,29 dB @ 2302,30 <strong>MHz</strong> M2: -28,64 dB @ <strong>2320</strong>,90 <strong>MHz</strong> M3: -24,73 dB @ 2423,30 <strong>MHz</strong><br />
Limit : -19,91<br />
Picture how is looking<br />
assembling with isolation<br />
relay and preamplifier.<br />
This preamplifier is DFC<br />
microwave cavity system<br />
with 0,4dB N/F. 3.th place<br />
in preamplifiers contest<br />
trough EME 2002<br />
conference Praha<br />
-40<br />
M1 M2<br />
M3<br />
2000 2050 2100 2150 2200 2250 2300 2350 2400 2450 2500 2550 2600<br />
Frequency (2000,0 - 2600,0 <strong>MHz</strong>)<br />
This picture show, how is possible<br />
install feed in the dish<br />
Resolution: 130 CAL: ON(COAX) CW: ON<br />
Date:<br />
Time:<br />
Model: S331A Serial #: 00906052<br />
Minimum SWR in free space is –40 dB in middle 13cm band. On all using QRG is<br />
SWR min.-25 dB. In the dish is possible setup –36 - -40 dB without problem. You<br />
can see the diagram how is looking feed inside dish on my web.<br />
DISH<br />
RX<br />
RX<br />
TX