Volvo XC90 - Intraphex
Volvo XC90 - Intraphex
Volvo XC90 - Intraphex
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Prodigy One<br />
TD-VV-<strong>XC90</strong>-KIT<br />
<strong>Volvo</strong> <strong>XC90</strong><br />
Installation<br />
Manual
Contacts<br />
www.directusnav.com<br />
support@directusnav.com<br />
Support: 810.355.2266<br />
Fax: 810-735-0175
Contents
Remove negative battery terminal.<br />
Remove center speaker grill<br />
*Use Special Tool 95112943<br />
Remove center speaker with frame
Remove front left door sill trim panel.<br />
Remove drivers side soundproofing panel .<br />
Remove left center console
Remove right center console.<br />
Remove passengers side front soundproof panel<br />
Remove rear door LH side sill trim
Remove left corner section from cargo area<br />
Remove right corner section from cargo area<br />
Remove floor hatch carpet
Remove panel at the rear roof near the antenna module<br />
Remove left side D-panel and side panel cargo compartment<br />
Install main cable harness into center speaker location for monitor
Route Power/Camera connection route in A-pillar lower position to rear section<br />
Route harness under sill trim to B-pillar<br />
Route the Prodigy One cable from sill trim to Prodigy One module located under<br />
front passengers seat
VNS receiver cable route to Prodigy One module located under front passengers seat<br />
Cable route to rear section<br />
Cable route to rear section
Center channel speaker assembly<br />
*Speaker assembly optional and not included with kit
Assemble center channel speaker and frame completely
Connector to the center dashboard monitor
Install center monitor / speaker assembly
Check if front monitor operates normally.<br />
Only then install the new grille to its place
Parking brake connector location.<br />
Route parking signal cable and connect to parking brake switch
REM module located in drivers side rear cargo area. Fuses will need to be added pto<br />
factory locations for trailer controller<br />
REM model year 2005 and up.<br />
Connect power cable, reverse signal to REM trailer socket B +30 and ignition +15
Verify that the cable layout and connections are correct, connected RSE components,<br />
reinstall all interior panels and connectors per instruction.<br />
Reinstall battery negative terminal