product class: clear epoxy hardener dot shipping information

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: ENVIROTEX LITE - HARDENER Page 1 of 3
PRODUCT CLASS: CLEAR EPOXY HARDENER
PRODUCT NUMBER: 02007, 02007C, 02008, 02008C, 02016, 02016C, 02032, 02032C, 02064, 02064C, 02128,
02128C,XTA-770
D.O.T. SHIPPING INFORMATION: PROPER SHIPPING NAME: CONSUMER COMMODITY
PROPER HAZARD CLASS: ORM-D
TRANSPORTATION EMERGENCY PHONE NUMBER: CHEMTREC (800) 424-9300
SECTION I
ENVIRONMENTAL TECHNOLOGY, INC.
300 SOUTH BAY DEPOT ROAD
FIELDS LANDING, CA 95537
PHONE NUMBER FOR INFORMATION: (707) 443-9323
DATE PREPARED: 3/2/2009
PREPARED BY: TECHNICAL DEPARTMENT
SECTION II Hazardous Ingredients/Identity Information
HAZARDOUS COMPONENTS
CAS
REG.NO.
APPROX
WT.%
ACGIH
TWA/TLV
OSHA
PEL
VAPOR
PRESSURE
mm Hg
NONYL PHENOL 84852-15-3 55 N/E N/E 400 PERCENT VOLATILE BY VOLUME N/A
MELTING OR FREEZING POINT N/E PERCENT VOLATILE BY WEIGHT N/A
VAPOR DENSITY (AIR=1) >1 EVAPORATION RATE (SLOWER LBS./GAL 8.1
THAN ETHER)
SOLUBILITY IN WATER:
VOC 0
SLIGHT
APPEARANCE AND ODOR: CLEAR, SLIGHTLY YELLOW, SOMEWHAT VISCOUS
SOLUTION WITH TYPICAL AMINE ODOR (SOMEWHAT FISHY)
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
FLASH POINT (METHOD USED): >200 ° F PMCC FLAMMABLE LIMITS: LEL: N/E UEL: N/E
LBS/GAL
VOC
GRAMS/LITER
EXTINGUISHING MEDIA: X FOAM X ALCOHOL FOAM X CO 2 X DRY CHEMICAL X WATER SPRAY
OTHER
SPECIAL FIRE FIGHTING PROCEDURES: USE NIOSH APPROVED PROTECTIVE CLOTHING INCLUDING POSITIVE
PRESSURE SELF CONTAINED BREATHING APPARATUS(SCBA). COOL UNOPENED CONTAINERS WITH WATER
SPRAY. UNUSUAL FIRE AND EXPLOSION HAZARDS: NONE EXPECTED
SECTION V - REACTIVITY DATA
STABILITY UNSTABLE X STABLE / CONDITIONS TO AVOID:
0

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: ENVIROTEX LITE - HARDENER Page 2 of 3
INCOMPATIBILITY (MATERIALS TO AVOID): ACIDS OR POLYMERS REACTIVE WITH AMINES
HAZARDOUS DECOMPOSITION OR BYPRODUCTS: BURNING PRODUCT WILL EMIT TOXIC OXIDES OF CARBON
AND NITROGEN.
HAZARDOUS POLYMERIZATION MAY OCCUR X MAY NOT OCCUR.
CONDITIONS TO AVOID: AVOID PRODUCT CONTAMINATION.
SECTION VI - HEALTH HAZARD DATA
ROUTE(S) OF ENTRY: INHALATION? YES SKIN? YES INGESTION? NOT LIKELY
HEALTH HAZARDS (ACUTE AND CHRONIC): DANGER - MATERIAL IS CORROSIVE AND COULD SEVERELY BURN
SKIN, EYES, RESPIRATORY TRACT, AND LUNGS IF ASPIRATED. COULD CAUSE BLINDNESS OR DEATH IF
SWALLOWED.
CARCINOGENICITY: NTP? NO IARC MONOGRAPHS? NO OSHA REGULATED? NO
SIGNS AND SYMPTOMS OF EXPOSURE: IRRITATION OF EYES, SKIN AND RESPIRATORY SYSTEM. CAUSES
PAIN IN EXPOSED AREAS; BLISTERS MAY FORM, ABDOMINAL AND DIGESTIVE TRACT PAIN IF SWALLOWED.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: PRE-EXISTING SKIN AND/OR RESPIRATORY
PROBLEMS COULD BE WORSENED BY EXPOSURE TO THIS PRODUCT.
EMERGENCY AND FIRST AID PROCEDURES: ORAL: DO NOT INDUCE VOMITING, CALL PHYSICIAN IMMEDIATELY!
EYES: SEVERRE IRRITANT TO EYES. IN CASE OF EYE CONTACT, FLUSH THOROUGHLY WITH WATER FOR 15
MINUTES AND GET PROMPT MEDICAL ATTENTION. SKIN: WASH IMMEDIATELY WITH SOAP AND RINSE
THOROUGHLY WITH WATER. DO NOT USE SOLVENTS OR ALCOHOL TO REMOVE PRODUCT FROM SKIN.
INHALATION: MOVE TO FRESH AIR. IF NOT BREATHING, ADMINISTER CPR. IF BREATHING IS DIFFICULT, GET
MEDICAL ATTENTION.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IF MATERIAL IS RELEASED OR SPILLED: VENTILATE AREA. WEAR PROTECTIVE
CLOTHING AND NIOSH APPROVED RESPIRATOR. DIKE AND CONTAIN SPILL. SPREAD ABSORBENT MATERIAL.
KEEP SPECTATORS AWAY.
WASTE DISPOSAL METHOD: NOT A RCRA HAZARDOUS WASTE AS SUPPLIED; USER MUST DETERMINE RCRA
STATUS AT TIME OF DISPOSAL. LANDFILL OR INCINERATE IN ACCORDANCE WITH EXISTING FEDERAL,
STATE, AND LOCAL REGULATIONS.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: STORE IN COOL DRY AREA, AWAY FROM STRONG
OXIDANTS, HEAT OR IGNITION SOURCES. ALWAYS KEEP CONTAINERS CLOSED. DO NOT GET ON SKIN OR
BREATHE VAPORS.
OTHER PRECAUTIONS: CLEAN UP ANY SPILLS IMMEDIATELY. WASH ANY AREAS OF BODY CONTACT
IMMEDIATELY.
SECTION VIII - CONTROL MEASURES
RESPIRATORY PROTECTION (SPECIFY TYPE): NIOSH APPROVED TO PREVENT INHALATION OF VAPORS; IF
VENTILATION IS INADEQUATE, SCBA MAY BE REQUIRED.
VENTILATION: LOCAL EXHAUST: IF REQUIRED. SPECIAL VENTILATION MUST BE ADEQUATE TO AVOID
BREATHING VAPORS.
USE IN SEALED EQUIPMENT AS MUCH AS POSSIBLE. MECHANICAL (GENERAL): REQUIRED
PROTECTIVE GLOVES: NEOPRENE OR RUBBER EYE PROTECTION: SAFETY GOGGLES
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: TO AVOID ALL SKIN CONTACT, WEAR A PROTECTIVE APRON
AND AVOID FOOT CONTACT.
WORK/HYGIENIC PRACTICES: WASH AT END OF WORK SHIFT, BEFORE EATING, SMOKING OR USING
RESTROOM. DO NOT RE-USE CONTAMINATED CLOTHING.

MATERIAL SAFETY DATA SHEET
PRODUCT NAME: ENVIROTEX LITE - HARDENER Page 3 of 3
REGULATORY INFORMATION: THIS PRODUCT IS REGULATED UNDER SARA TITLE III SECTION 311 AS
ACUTELY HAZARDOUS.
All information, recommendations, and suggestions appearing herein concerning our product are based upon tests and
data believed to be reliable. However, it is the user's responsibility to determine the safety, toxicity, and suitability for his or
her own use of the product described herein. Since the actual use by others is beyond Environmental Technology, Inc.'s
control, no guarantee, expressed or implied, is made by Environmental Technology, Inc. as to the effects of such use, the
results to be obtained, or the safety and toxicity of the product.