ENGINE WESTERBEKE
ENGINE WESTERBEKE
ENGINE WESTERBEKE
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
35D<br />
Three<br />
W<br />
<strong>WESTERBEKE</strong><br />
Engines & Generators<br />
TM<br />
Performance Data<br />
Specifications<br />
Number of cylinders<br />
3 Cylinder vertical in-line<br />
Cycles<br />
4 Cycle<br />
Displacement<br />
80.43 cu. in. (1.318 liter)<br />
Bore and stroke<br />
3.07” x 3.62” (78 mm x 92 mm)<br />
Compression ratio 22:1<br />
Maximum angle of installation Not to exceed 14˚<br />
Maximum angle of operation Not to exceed 30˚ for 30 min.<br />
Crankshaft, direction of rotation Counterclockwise as viewed<br />
from flywheel end<br />
Propeller shaft, direction of rotation Right hand – std. trans.<br />
Dry weight<br />
386 lbs (175.1 kilos)<br />
Combustion system<br />
Swirl type<br />
Aspiration<br />
Naturally aspirated<br />
Lubrication system<br />
Forced lubrication by trochoid pump<br />
Cooling system<br />
5 quarts (4.73 liters)<br />
Starting aid<br />
12 volt sheathed type glow plug<br />
Engine stop<br />
Manual type<br />
Fuel injection pump<br />
Bosch type<br />
Governor<br />
Centrifugal type<br />
Injectors<br />
Throttle type<br />
Fuel filter<br />
Primary<br />
Lube oil filter<br />
Full flow, spin-on element<br />
Lubricant capacity<br />
.98 U.S. gallons (3.7 liters)<br />
Fuel transfer pump<br />
Electric<br />
Fuel supply and return piping 1/4” ID (6.35 mm) minimum<br />
3/8” ID (9.53 mm) maximum<br />
Starting motor<br />
12 volt, solenoid actuated<br />
Battery charging alternator 50 ampere (12 volts)<br />
Cold cranking amps<br />
237 amps<br />
Alternator/regulator<br />
Automatic, solid state built-in<br />
Electrical system<br />
12 volts DC, negative ground<br />
Dimensions<br />
Inches (millimeters)<br />
Construction – Engine Components<br />
Cylinder head<br />
Cylinder block<br />
Crankshaft<br />
Valves<br />
Fuel System<br />
Intake system<br />
Cooling system<br />
Exhaust manifold<br />
Standard Equipment<br />
Cast Iron<br />
Cast Iron<br />
Forged crankshaft, four main bearings<br />
Overhead valves, rotating type<br />
Self bleeding<br />
Tuned intake silencer<br />
for maximum noise reduction<br />
Fresh water-cooled with tube and<br />
shell type heat exchanger<br />
Cast aluminum, fresh water-cooled with<br />
built-in expansion tank<br />
Standard gear ratio 2.0:1<br />
Mounting centers 14.6”, 16.0” or 18.5”<br />
Flexible mounts<br />
Adjustable fail safe<br />
rubber type<br />
Flow control domestic hot water connection<br />
Coolant recovery tank<br />
Battery charging alternator<br />
50 amp<br />
Starting aide<br />
Control brackets<br />
For all control attachments<br />
Prewired Engine<br />
Gear-driven raw water pump<br />
Lube oil drain hose<br />
Transmission oil cooler<br />
Oil fill<br />
Top and service side<br />
Circuit breaker protected DC electrical system<br />
Operator’s Manual and Parts List<br />
Optional Equipment<br />
Captain panel with alarm (tachometer with lights)<br />
Admiral panel with alarms (tachometer with gauges)<br />
Dual station senders<br />
Other gear ratios<br />
Consult local Distributor<br />
72 amp alternator in place of standard<br />
Remote expansion tank<br />
Fuel/water separator<br />
Muffler and fittings<br />
“A” on board spare parts kits<br />
“B” extended cruising spare parts kits<br />
Anti-siphon valve for overboard cooling discharge water<br />
Technical Manual<br />
Exhaust connection (water injected 45˚ or 90˚elbow)<br />
Propeller shaft couplings (rigid/flexible) – available standard sizes<br />
Authorized Dealer<br />
Westerbeke Corp., Myles Standish Industrial Park, 150 John Hancock Road, Taunton, MA 02780-7319, U.S.A. • TELEPHONE : (508) 823-7677 • FAX: (508) 884-9688 • Website: www.westerbeke.com<br />
Specifications Subject to Change without Notice.<br />
DPS 3M 3/02