Front-Mounted Mower - MULAG Fahrzeugwerk, Heinz Wössner ...

MULAG – the Answer to all Questions
in the field of Roadside Maintenance
The modular concept of MULAG power arms and the
wide range of working attachments make their use economical
and efficient: All tasks of road maintenance can
be handled in a flexible and quick way.
Due to the high quality of workmanship downtime can
be reduced and long repair times can be avoided. We
can offer you conclusive solutions for roadside maintenance.
Technical Specifications of the FME 600
Designed for Model U 300 / U 400 / U 500
Type of Fitting Front mounting plate size 3 and 5
Attachments Fitting Quick-change device
Reach Up to 7.2 m right- and left-hand side
Lateral Shift 1300 mm
Rotational range of
the Power Arm
240 degrees
Rotating Device for - mechanical 360 degrees / 6 degree steps
Working Attachments - hydraulical 230 degrees continuously (SA)
Drive - vehicle power hydraulic system
- rear PTO-shaft
Cutter Shaft Control Electrical with Safety-Stop within 4 sec.
for all working attachments
Transport height approx. 3.6 m (depends on carrier vehicle)
Transport width 2.1 m
Control - electro-hydraulic with two stage AES
- CAN-Bus / proportional with continuous
flail arm relief control type AER (SA)
- CAN-Bus / proportional with automatic
power arm relief control Mähtronic (SA)
Parking the power arm at the rear of the vehicle results in a
well balanced load distribution on the axles without losing the
dynamics of vehicle movement.
Reach diagram Diagram of of the the FME FME 600 600
Distributor Manufacturer
MULAG Fahrzeugwerk
Heinz Wössner GmbH u. Co. KG
Gewerbestraße 8
77728 Oppenau
Germany
Tel +49-(0)7804-913-0
Fax +49-(0)7804-913-163
E-Mail info@mulag.com
Web www.mulag.com
FME 600
MFK 500-T
© MULAG Fahrzeugwerk Heinz Wössner GmbH u. Co. KG // Changes without notice, Dok 0408_309en