Hot Melt Systems - Interempresas

ACCESSORIES
Edge Dispensing Manifold Applicators
Commonly used in corrugated or folded carton applications to dispense hot melt in either horizontal or vertical modes. Manifold
applicators are available in versions to take one, two or four dispense valves. Each applicator is available in 110V and
220V models and each requires a separate 3-way electric solenoid, available in 24VDC,
110VAC and 220VAC.
Valves
Dispense valves are available in-line (extrusion) for top carton applications
and right angle models for bottom carton applications, ensuring
hot melt adhesive is always dispensed with gravity.
Operation
Material is fed to the manifold by a heated hose; a control cable from the hose
connects carries the necessary circuit to heat the manifold, it also provides the
signal to the external 3-way solenoid. Clean factory air is connected to the air solenoid
and switched to operate the manifold. Module valves are fitted to the manifold to
dispense the material.
Dispensing Manifold Applicators
Manifold Type Voltage
HM071 1 Valve 110V
HM072 1 Valve 220V
HM073 2 Valve 110V
HM074 2 Valve 220V
HM075 4 Valve 110V
HM076 4 Valve 220V
Module Valves
Valve Type Inch mm
HM00 Standard
HM43 1 Valve 0.015 0.381
HM42 2 Valve 0.020 0.508
HM41 2 Valve 0.025 0.645
Air Solenoids
Solenoid System Use Type Voltage
HS3115 Edge Manifold 3-Way 115VAC
HS3220 Edge Manifold 3-Way 220VAC
HS324 Edge Manifold 3-Way 24VDC
Nozzle Extrusion and Right Angle
Nozzle Description Inch mm
HN31 Nozzle Extrusion 0.010 0.254
HN32 Nozzle Extrusion 0.012 0.305
HN33 Nozzle Extrusion 0.015 0.381
HN34 Nozzle Extrusion 0.017 0.432
HN35 Nozzle Extrusion 0.020 0.508
HN36 Nozzle Extrusion 0.025 0.645
HN37 Nozzle Extrusion 0.030 0.762
HN40 Nozzle Extrusion 0.040 1.016
HN11 Nozzle Right Angle Adapter
HN25 Nozzle for Right Angle 0.010 0.254
HN16 Nozzle for Right Angle 0.015 0.381
HN18 Nozzle for Right Angle 0.020 0.508
HN27 Nozzle for Right Angle 0.025 0.645
HN28 Nozzle for Right Angle 0.030 0.762
13