hoses

HOSES
General Information
GS-FLANGE
SYSTEM
GS-Hydro supplies comprehensive selection of hoses and hose couplings which
include BSP, NPT, JIC, Metric, SAE 3000/6000 Flanges and GS Retain Ring Flanges
to various applications.
GS-Hydro hoses can meet several industry standards and type approvals of main
certificate institutes. Please specify your requirements when ordering.
TUBES & PIPES
CLAMPS
Working Pressures / High Pressure Hoses
Hose type
In order to guarantee peak performance of the hose, you
should select the type of the hose according to specific
conditions under which it is to be used. Therefore it is essential
to obtain precise information about the application
and required connections. Make sure that all requirements
of the application are fulfilled.
The system pressure should not exceed published working
pressures. Approved working pressures are indicated
in the enclosed table.
Hose dimension
3/16” 1/4” 5/16” 3/8” 1/2” 5/8” 3/4” 1” 1 1/4” 1 1/2” 2”
P1T 120 120 120 120
G1 /1SN 225 215 180 160 130 105 88 63 50 40
C1TH / G1H 195 160 140 105 90 70 63 50 40
G2 / 2SN 400 350 330 275 250 215 165 125 90 80
CM2T 400 350 330 275 250 215 165
G2L 400 330 275 250 215 165 125
1PW / 2PW 200 200 200
4SH / GH506 420 385 350 300 250
M3K 210 210 210 210 210 210 210
M4K 280 280 280 280 280
M5K 350 350 350 350
M6K 420
G3K 210 210 210
G4K 280 280 280 280 280 280
G5K 350 350 350 350 350 350 350
G6K 420 420 420 420 420 420 420 420
R7 190 175 155 140 105 87 70
R8 350 280 245 195 162 142
2A 690 690 560
T9 / PTFE 252 172 142 96 63
345
MACHINES ADAPTORS
VALVES
BITE TYPE
FITTINGS
SAE J514 JIC
FLARE FITTINGS
HOSES &
HOSE COUPLINGS
SPECIAL
SOLUTIONS
Above pressures = Approved working pressures.
Burst pressure = 4 x working pressure
TECHNICAL
INFORMATION