29.04.2015 Views

27 Operator's Manual.. - Marlow-Hunter, LLC

27 Operator's Manual.. - Marlow-Hunter, LLC

27 Operator's Manual.. - Marlow-Hunter, LLC

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

fuel in the supply lines to the filters and engines ). Disconnecting<br />

these fittings without properly bleeding the system of fuel could<br />

result in emptying the fuel filters and causing a fuel spill. Only<br />

a qualified technician should ever make repairs to your fuel<br />

system.<br />

The fuel supply valves are the “ball type” valves. Turning<br />

the handle so it is perpendicular to the valve body shuts<br />

off the supply or return. Turning the handle so it is in line<br />

with the valve body opens the valve, as shown in Fig.<br />

5.4.<br />

Example of Fuel Supply Lines and Valves<br />

<strong>Hunter</strong> <strong>27</strong> • Fuel Systems<br />

due to contaminated fuel.<br />

In the Figure. 5.6, page 5.7 you will find an illustration<br />

for the Racor Fuel Water separator (commonly referred<br />

to as the fuel filter). This will break down the components<br />

of the filter and their uses within the filter.<br />

Flow of fuel.<br />

Fig. 5.5<br />

To service the filter:<br />

1. Make sure the engine is off.<br />

Open<br />

Closed<br />

Rotating the handle 90° from the<br />

fuel line, closes the valve.<br />

Fig. 5.4<br />

2. Close shut-off valve between fuel tank and filter if<br />

applicable.<br />

3. Open vent plug on mounting head with a ½” wrench.<br />

Note: Do not leave drain open for very long as it will<br />

empty filter of all fuel.<br />

5.4 Filters (Fuel Water Separators)<br />

The fuel supplied to the engine may contact impurities<br />

found in the fuel tanks or in the fuel from your supplier.<br />

If these impurities are not removed prior to starting<br />

the engine, performance may be seriously affected.<br />

Removal of the fuel impurities is accomplished by external<br />

fuel filters.<br />

5.4.1 Main Engine Filters<br />

Each engine has a separate filter located away from the<br />

engine. Check the Fuel Arrangement illustration at the<br />

end of this chapter for the exact location of these filters.<br />

An authorized service technician should replace all filters<br />

annually prior to spring launch. They may need more frequent<br />

replacement if you notice poor engine perfomance<br />

4. When fuel is detected coming out of drain, close drain<br />

quickly.<br />

5. Close vent plug and tighten snugly.<br />

6. Open shut off valve.<br />

Follow priming instructions.<br />

Consult your owner’s packet for more information concerning<br />

this filter or for replacement parts.<br />

5.4.5 Here are some general guidelines for fueling<br />

your boat:<br />

! CAUTION !<br />

Using the wrong type of fuel will result in severe<br />

damage to the engines. Refer to your owner’s<br />

manual for fuel recommendations.<br />

5.5

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!