Hand and Power Tool Safety - Technology

More documents

Recommendations

Info

✔ The manufacturer's safe operating pressure for hoses, pipes, valves, filters, <strong>and</strong> other fittings shall not be exceeded, ✔ The use of hoses for hoisting or lowering tools shall not be permitted. ✔ All hoses exceeding 1/2-inch inside diameter shall have a safety device at the source of supply or branch line to reduce pressure in case of hose failure.
✔ Noise is another hazard. Working with noisy tools such as jackhammers requires proper, effective use of hearing protection. ✔ When using pneumatic tools, employees must check to see that they are fastened securely to the hose to prevent them from becoming disconnected. ✔ A short wire or positive locking device attaching the air hose to the tool will serve as an added safeguard.
Page 2 and 3: ✔ For General Industry ✔1910 Su
Page 4 and 5: ✔ Employers shall not issue or pe
Page 6 and 7: ✔ Appropriate personal protective
Page 8 and 9: ✔ The greatest hazards posed by h
Page 10 and 11: ✔ Around flammable substances, sp
Page 13 and 14: ✔ Offer more power, adaptability
Page 15 and 16: ✔ The following information offer
Page 17 and 18: ✔ Be aware of all power lines and
Page 19 and 20: ✔ The following general precautio
Page 21 and 22: ✔ Tools should be maintained with
Page 23 and 24: ✔ Under certain conditions, even
Page 25 and 26: ✔ These general practices should
Page 27 and 28: ✔ Don't use an accessory or attac
Page 29 and 30: ✔ Failure to ring test could resu
Page 31 and 32: ✔ Portable grinding tools need to
Page 33 and 34: ✔ Always wear safety goggles or s
Page 35 and 36: ✔ Is the blade guard working? Che
Page 37 and 38: ✔ Available in a variety of types
Page 39 and 40: ✔ Check auxiliary handles, if par
Page 41 and 42: ✔ Pneumatic tools are powered by
Page 43: ✔ Pneumatic power tools shall be
Page 47 and 48: ✔ Using pneumatic tools requires
Page 49 and 50: 4. To ensure the best connection, c

Hand and Power Tool Safety - Technology

Create successful ePaper yourself

Delete template?

Save as template?