Zalacznik_nr_4.9.5-Raport_z_odzyskania_danych_FMS-wersja_angielska
Zalacznik_nr_4.9.5-Raport_z_odzyskania_danych_FMS-wersja_angielska
Zalacznik_nr_4.9.5-Raport_z_odzyskania_danych_FMS-wersja_angielska
- No tags were found...
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Universal Avionics Systems Corporation June 25, 2010<br />
<strong>FMS</strong> Data Extraction for NTSB Identification: ENG10SA025<br />
16. Verify that the baud rate is set to 9600.<br />
17. Using the "Browse" button, specify the ASCII dump file path and name<br />
U:\NTSB\Tupolev\SN281\DumpX.txt.<br />
18. Using the "Browse" button, specify the converted binary file path and name<br />
U:\NTSB\Tupolev\SN281\BinaryX.bin.<br />
19. Select the "Run Memory Download And Binary Conversion" run option.<br />
20. Click the "Run" button. An instruction window will be displayed. The first two items in<br />
the instruction window just serve as reminders to make sure the monitor port connection<br />
and software load jumper have been installed.<br />
21. Turn ON the <strong>FMS</strong> (ON/OFF DIM).<br />
22. Click the "OK" button after you've turned on the <strong>FMS</strong>. The download should begin. A<br />
progress bar will be displayed during the download. A "CDU DATA BUS FAILURE"<br />
message will be displayed on the <strong>FMS</strong>. This is expected.<br />
23. When the download is complete, verify that both the ASCII dump file and the binary file<br />
have been generated, and perform a sanity check on the contents of the ASCII dump file<br />
(i.e., review some known memory locations for valid content).<br />
24. Turn the <strong>FMS</strong> off, and turn off the power supply.<br />
25. Remove the CPU board from the lab <strong>FMS</strong>, and remove the boot jumper from the board.<br />
A-2
Change language