skateboards 2013 - Carver Skateboards

C7 Link Set C7 Spring C7 Thrust Bearing Set C7 Upgrade Kit
C7 Link Set
We’ve upgraded our link so it’s made from Grade 8 steel with extra side ribs at the 90 degree bend for extra strength, and we’ve added a C-clip to the Spring
Bolt so that if it ever loosens up it will never fall out. It’s easy to install, just pull the clip off the groove, assemble the C7 as you normally would and then snap the C-clip on.
C7 Spring
We’ve made this custom Spring out of Rocket Wire, the best aerospace material we could find, for the longest continuous use possible. We also go to the extra steps of peening
the surface, which is a way to polish the surface so there are no minute cracks that can grow over time and contribute to Spring failure, and we lightly oil them to prevent
surface rust that also shortens duty cycle. We recommend that you use a liberal amount of Marine Grease (what we use at the factory) or a high quality bicycle bearing grease
for quiet and long-lasting action.
C7 Thrust Bearing Set
C7 Thrust Bearing Set: Like your wheel bearings, water, sand and heavy use can rust and/or wear out your bearings, so if you’re hard on your C7 truck you can always bring
that smooth rotation back to new again with this easily installed double Thrust Bearing Set with double-thick Thrust Washers”
C7 Upgrade Kit
Starting in 2009 we upgraded our Bottom Thrust Bearing Washers from standard thickness to double thickness. These heavy-duty Washers are much
more durable than the standard thickness Washers, but in order to fit them into the C7 we had to make more room on the Arm Bearing Plate for
them. So if you have a pre-2009 C7 and you need to replace your Thrust Bearings for any reason, whether because you have a cracked
Washer or a rusty or worn out Thrust Bearing Set, this Kit will provide you with all the parts you need to rebuild your C7 with the latest
improvements, including our newest Link, made with Grade 8 steel with extra side ribs at the bend for extra strength.
26