Bumper Removal PDF - Wak-TT

More documents

Recommendations

Info

<strong>Wak</strong>s Wide Webfile://C:\Documents%20and%20Settings\WKhan2\Local%20Settings\Temporary%20...Page 4 of 1026/05/2004TIP: the pegs are 2 stage then they drop out which you don't want to happen.....
<strong>Wak</strong>s Wide Webfile://C:\Documents%20and%20Settings\WKhan2\Local%20Settings\Temporary%20...Page 5 of 1026/05/2004Use a small rod but hold your finger tight against the rod around 5mm back, whenyou push the peg let your finger be the stop point to avoid the peg dropping into theengine bay.TIP: Once the pegs are pushed, use 2 flat tools to lever the head and entire peg bodyout, as they are under tension, they could pop out, make sure a thumb or finger isstopping them to catch them before they fly off and disappear into the engine bayRemove the entire plastic cover across the front of the car, you will then have accessto the 6 Torx screws at the front holding the bumper....remove them, slide off themetal clamping strip and put it to one side.
Page 1 and 2: Waks Wide Webfile://C:\Documents%20
Page 3: Waks Wide Webfile://C:\Documents%20

Bumper Removal PDF - Wak-TT

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?