14AS STATIONARY-UNITS OF LESLIE SPEAKERSLINEINPUTTUBEDRIVELEVELVOLUMETUBEMODEBASS MIDDLE TREBLEHORNLEVELSUBWOOFERVOLUMESUBWOOFERLINE OUTTUBE OFF MAX 10HARDSOFT +5-5 +5 -5-5 +50 10 00 10 Tip :BassRing :FullTONE1-2TONE3-4TONE1-2TONE3-4BASSTREBLEBASS TREBLE REVERBBASSTREBLEBASS TREBLE REVERBREV.REV.VOLUME 1VOLUME 2OFF ONVOLUME 3 VOLUME 4MASTER VOLUMEVOLUME 1VOLUME 2OFF ONVOLUME 3 VOLUME 4MASTER VOLUMEINPUT 1 INPUT 2 INPUT 3INPUT 4LINEOUTINPUT 1 INPUT 2 INPUT 3INPUT 4LINEOUTPOWERPOWERAC INONAC INONOFFOFFYou can use these amps as stationary units for reproducingthe straight Drawbar or orchestral sounds, if you have aHammond Organ with <strong>Leslie</strong> connectors of 3 channel specs.,such as SK1/2, A-405 or the XK-3C and the <strong>Leslie</strong> 3300 or2101, with a “Stationary Out” jack.Connect the Stationary Out jack of the <strong>Leslie</strong> speaker and theINPUT jack of this unit, and set the “EXT. LESLIE CHAN-NEL” parameter on the Hammond Organ to 3.On the SK1/SK2, connect the Line Out jack of the SK1/2and the INPUT jack of this unit, and set the “EXT. LESLIECHANNEL” parameter on the Hammond Organ to 1.Adjust the volume balance of each speaker, playing eachchannel of the rotary and stationary on the Hammond Organrespectively.The above figure shows an ideal setting for SK2, <strong>Leslie</strong> 3300series and two sets of this unit.<strong>SPA</strong>-<strong>150R</strong>-L Owner’s Manual
SPECIFICATIONS15Speakers25cm (10 inch) high-power woofer, 2 - 10cm (4 inch) tweeterType2-way, Bass reflex enclosureOutput Power150W (music), 200W (peak)Maximum Sound Pressure Level119dB SPL (1m)Frequency Range45Hz - 15kHzControlVOLUME(1 - 4), BASS/TREBLE(1-2, 3-4), REVERB, REV., MASTERVOLUME, POWERTone ControlChannel 1-2, 3-4 individualBASS: ±8dB at 50Hz, TREBLE: ±10dB at 10kHzReverbDigital Reverb (Channel 3-4 is switchable)ConnectionsINPUT 1 - 4sensitivity: -40dBu(8mV) - +16dBu(5V), impedance: 50kW, monophone jackLINE OUToutput level: 0dBu (0.775V), impedance: 1kW, mono phone jackPower RequirementsAC100 - 240V 50/60HzPower Consumption45WDimensionsW32 x H61 x D31 cm / W12.5 x H24 x D12.2 inchWeight15 kg / 33 lbsOthersSpeaker stand (ø35mm / 13/8 DIA) correspondenceMAIN FEATURESu A high quality class-D digital amplifier is mounted in thisunit. Thus, it gives a very high quality tone from low volumeto the full power. At the same time, we have successfullyreduced both the power consumption and the totalweight.u The cabinet, exclusively designed for the special 25 cm(10 inch) high power speaker, is carefully tuned acoustically.As the result, powerful bass sound is expected as iffrom a large size speaker.NOTE: In case this unit is used on the stand etc. or, depending on theenvironment, the bass sound may be insufficient.u There are 4 channel inputs, all of which correspond fromthe microphone to the line. So it is possible to use thisunit for various purposes as the external amplifiers forensembles, keyboards, etc.u This unit has a built-in digital reverb. So it is ideal forplaying harmonicas and also as a vocal amplifier.u The tone control is equipped in 2 independent groups:Channel 1 - 2 and Channel 3 - 4.BLOCK DIAGRAM, FREQ. RESPONSE12VolumeToneControlMasterVolumeClass DPowerAmplifierCrossoverNetworkHFSame as aboveRev.3-4ReverbLevelLFDigitalReverbLine Out