EVIL omen manual 2 - Paintball Solutions

Omen Manual 2.0 6/21/05 9:56 AM Page 24O M E N 2.0 BOARD PROGRA M M I N GPROGRAMMING EXAMPLESTo set rate of fire to 20bps:Start with the power turned off, hold in trigger and turn power on. Wait for about 2 secondsand LED will come on, release trigger and then pull it once more and hold until the LED turnsoff, this selects the Ball/Second register. Starting at five, click the trigger while counting and holdthe trigger in on the 20th count. Hold until the LED goes out, meaning the value has beenaccepted, and then release the trigger once again. It will then reboot with the new valueindicated by a single flash and it will then be live and ready to fire.Setting Electronic Trigger Sensitivity to 5 pointsStart with the power turned off, hold in trigger and turn power on. Wait for about 2 secondsand LED will come on, release trigger and then pull it once and release, then pull a second timeand hold until the LED turns off, this selects the de-bounce register. Starting at one, click thetrigger while counting and hold the trigger in on the 5th click. Hold until the LED goes outmeaning the value has been accepted and then release the trigger once again.It will then reboot with the new value indicated by a single flash and it will then be live andready to fire.NOTE: If at any point a mistake is made just turn power off and start again. Theselected values are stored in permanent memory and will remain set even withouta battery connected.WHEN SETTING BALLS/SECOND ALWAYS START COUNTING AT FIVE BECAUSE FIVE IS THELOWEST SETTING. WHEN SETTING THE ELECTRONIC TRIGGER SENSITIVITY ALWAYS STARTCOUNTING AT ONE. ALL PROGRAMMING IS DONE USING THE LED ON THE RIGHT SIDE OFTHE EVIL OMEN TRIGGER FRAME.charging EVIL O M E N 2.0The OMEN battery is a 9 volt rechargeable battery. The battery needs a full 22 hours to chargebefore it is full. The battery does not come fully charged. For best long term battery life, EVILrecommends you charge your OMEN frame for a full 22 hours before using it. You can useregular 9 volt batteries with this frame if your rechargeable battery is dead or you want to playwith the frame right away. A blinking on/off indicator light means your OMEN frame needs tobe charged right away.Charge PortTURN MARKER OFF TO CHARGEMaintaining EVIL OMEN 2.0The trigger frame handlemight get warm duringcharging.Loss of rear gripframescrew (59) can cause searnot to drop and imitate adead battery.The EVIL OMEN is easy to strip for cleaning and basic maintenance. Regular cleaning andmaintenance is highly recommended, including frequent checks of all air systemcomponents. Keep screws tightened. Replace worn components with factory parts; allleaks must be repaired promptly. Air system repairs are best performed by the factory oran authorized factory repair facility; contact PMI for information regarding authorized repairfacilities: 1.800.579.1633.WARNINGDO NOT ATTEMPT TO PERFORM MAINTENANCE PROCEDURES UNLESS QUALIFIEDTO DO SO. DO NOT DISASSEMBLE MARKER UNTIL IT IS COMPLETELY DRAINEDOF COMPRESSED GAS OR AIR AND ALL PAINTBALLS HAVE BEEN REMOVED. ALLFILLING OF COMPRESSED GAS OR AIR CYLINDERS MUST BE DONE BY QUALIFIEDPERSONS.CONTACT PMI, INC., FOR REPAIR ASSISTANCE AND INFORMATION REGARDINGAUTHORIZED REPAIR FACILITIES. PHONE 800.579.1633; WWW. BUYPMI.COMPAINTBALL MARKER AIR SYSTEMS MUST BE REPAIRED OR REPLACED ONLY WITHTHE CORRECT PRESSURE RATED COMPONENTS.2425