Gears - Electronic Fasteners Inc

MITER & BEVEL GEARSPITCH STYLE BORE FACE MATERIAL AGMA QUALITY PRES. ANGLE64Matched SetsPIN OR CLAMP 3/16” 5/32” 303 Stainless Steel or2024-T4 AluminumAnodized10 20ºPINCLAMPHUBSTYLESTOCK STOCK NO. OFNO. NO. P.D. RATIO TEETH A MATERIALM64N-1M64N-1-C.50032STAINLESS STEEL1 to 1.562.500 32 ALUMINUMM64N-1S M64N-1S-C.500321 to 1.500 32.562 STAINLESS STEELM64N-1A M64N-1A-C.500321 to 1.500 32.562 ALUMINUMM64N-2M64N-2-C.500 (PINION)32STAINLESS STEEL1 to 2.7501.000 (GEAR) 64 ALUMINUMM64N-2S M64N-2-CS.500 (PINION)301 to 21.000 (GEAR) 64.750 STAINLESS STEELM64N-2A M64N-2-CA.500 (PINION)301 to 21.000 (GEAR) 64.750 ALUMINUMM64N-3M64N-3-C.500 (PINION)32STAINLESS STEEL1 to 31.0001.500 (GEAR) 96 ALUMINUMM64N-3S M64N-3S-C.500 (PINION)321 to 31.500 (GEAR) 961.000 STAINLESS STEELM64N-3A M64N-3A-C.500 (PINION)321 to 31.500 (GEAR) 961.000 ALUMINUMM64N-4M64N-4-C.500 (PINION)32STAINLESS STEEL1 to 41.2502.000 (GEAR) 128 ALUMINUMM64N-4S M64N-4S-C.500 (PINION)321 to 42.000 (GEAR) 1281.250 STAINLESS STEELM64N-4A M64N-4A-C.500 (PINION)321 to 42.000 (GEAR) 1281.250 ALUMINUMM64N-5M64N-5-C.500STAINLESS STEEL1 to 1 32 .562.500 ALUMINUMM64N-6M64N-6-CS.500 (PINION)32STAINLESS STEEL1 to 2.7501.000 (GEAR) 64 ALUMINUMM64N-1P M64N-1P-C .500 1 to 1 32 .562 STAINLESS STEELM64N-1G M64N-1G-C .500 1 to 1 32 .562 ALUMINUMNote: Gears will mesh at right angles only when used as sets described in chart.Clamp hubs are 1/32” longer than pin hubs.For Couplings See Section G.For Shafts, Bearings and Collars See Section I.1-800-232-BERG B 228 WWW.WMBERG.COM