International Paint Ltd. Safety Data Sheet EMB117 INTERGARD 410 ...

Page 6 of 10Respiratory protectionIf workers are exposed to concentrations above the exposure limit they must use the appropriate,certifiedrespirators.For maximum protection when spraying this product it is recommended that a multi layercombination type filter, such as ABEK1, is used. In confined spaces use compressed air or fresh airrespiratory equipment.Thermal hazardsNo Data AvailableSECTION 9: Physical and chemical propertiesAppearance Coloured LiquidOdour Smell of SolventOdour thresholdNot MeasuredpHNot MeasuredMelting point / freezing point (°C)Not MeasuredInitial boiling point and boiling range (°C) 108Flash point (°C) 30Evaporation rate (Ether = 1)Not MeasuredFlammability (solid, gas)Not ApplicableUpper/lower flammability or explosive limits Lower Explosive Limit: Not MeasuredUpper Explosive Limit: Not MeasuredVapour pressure (Pa)Not MeasuredVapour densityHeavier than air.Relative density 1.57Solubility(ies)ImmisciblePartition coefficient n-octanol/water (Log Kow) Not MeasuredAuto-ignition temperature (°C)Not MeasuredDecomposition temperature (°C)Not MeasuredViscosity (cSt) 1529.2. Other informationNo further informationSECTION 10: Stability and reactivity10.1. ReactivityNo data available10.2. Chemical stabilityStable under recommended storage and handling conditions (see section 7).When exposed to hightemperatures may produce hazardous decomposition products such as carbon monoxide, carbon dioxide,oxides of nitrogen and smoke.Keep away from oxidising agents, strongly alkaline and strongly acid materials in order to avoid possibleexothermic reactions.10.3. Possibility of hazardous reactionsMay react exothermically with: oxidising agents, strong alkalis, strong acids.10.4. Conditions to avoidStable under recommended storage and handling conditions (see section 7).10.5. Incompatible materialsKeep away from the following materials: oxidising agents, strong alkalis, strong acids.10.6. Hazardous decomposition products