Ford Racing Performance Parts Laguna Gauge Pack Installation ...

More documents

Recommendations

Info

Ford Racing Laguna Gauge Pack Installation Manualwire harness pass through. It is best to use a die-grinding bit to make the centerhole. Start with a~" hole made by a drill bit, then enlarge the hole with the diegrindingbit.Step 5: Install mounting bracket to dash as shown below using the 4 screwsprovided- do not over tighten .WWW.FORDRACINGPARTSDIRECT.COMVl.OPg6of12
Ford Racing Laguna Gauge Pack Installation ManualStep 6a: Pass gauge pod wire harness through IP dash pad and mount thegauge pod to the mounting bracket by sliding the clip on the back of the gaugepod into the socket of the mountin~ brac~et (refer t...,..o_.~_i_ct_u_re_b,~e-~~---'!t"'Step 6b: Install remaining two screws through front of gauge pod to secureinstallation of the to the mountin bracket.WWW.FORDRACINGPARTSDIRECT.COMVl.O Pg7of12 ;
Page 1 and 2: Ford Racing Laguna Gauge Pack Insta
Page 5: Ford Racing Laguna Gauge Pack Insta

Ford Racing Performance Parts Laguna Gauge Pack Installation ...

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?