RF BOX - Fenix

Installation Instructions
Working Principle
G
The radio receiver has been designed to
operate in conjunction with thermostats
and programmable room thermostats for
controlling heating devices.
Operating Modes
Press push-button on upper face of
receiver
for selecting “ Auto “ or “ Prog “ mode.
• The “ Auto “ mode is product normal
operating mode.
Il allows:
Output operation based on radio
receivers, and Setting output priority by
pressing shortly receiver’s push-button
• The “ Prog “ mode is the product
configuration mode.
It is used:
- To configure one radio receiver with
receiver’s output, and
- To delete the receiver.
Configuration
To configure one receiver’s output :
- Press the pushbutton of the receiver for
more than 3 seconds.
- The indicator light OK flickers. You are in
configuration mode.
- Using the transmitter, press the ” + ” button
of the Thermoflash Digi 2 in mode
CONF or the MEMO button (for other
transmitters) for 3 seconds.
- The indicator light OK of the receiver
stops flickering, showing that the transmission
/ reception link has been established.
- The receiver returns to the auto mode.
1 Channel 433 MHz
Receiver
1 Contact 16A AC1 Free of Potential
Product Display
➀ BP
Configuration
and priority
setting
➁ Network
presence
➂ ON/OFF
output
display
Total or partial clearance:
Total clearance:
For clearing all transmission / reception links:
- Press the receiver’s pushbutton for more
than 10 seconds.
- The indicator light OK flickers slowly, then
more quickly.
- Press again the receiver’s pushbutton for
more than 3 seconds.
- The indicator light OK stops flickering, all
codes have been cleared.
- The receiver returns to the auto mode.
Partial clearance:
For clearing one transmission / reception link:
- Press the receiver’s pushbutton for more
than 10 seconds.
- The indicator light OK flickers slowly, then
more quickly.
- Using the decoding transmitter, press the ”+”
button of the Thermoflash Digi 2 in mode
CONF or the MEMO button (for other transmitters)
for 3 seconds.
- The indicator light OK stops flickering, the
link between this transmitter and the receiver
has been cleared.
- The receiver returns to the auto mode.
Priority Setting
Manual control is provided for this
product.
- Press shortly receiver’s BP (< 3sec),
Each press reverses output state.
Note:
Radio control retains priority.
Technical Specifications
• Electrical characteristics
- Supply voltage: 230V +10% at -15%
- Minimum load: 12V 100mA
- Output: 1 changeover contact free of
potential
- Switching capacity:
AC1: 16A 250V
Inductive: 3A (cos ϕ = 0.6)
• Functional characteristics
- RF: 433.92MHz
- Degree of protection: IP43
- Isolation class: II
- Mechanical protection: IK3
- Teaching capacity: up to 16 transmitters.
• Environment
- Operating temperature: -10°C to +60°C
- Storage temperature: -20°C to +70°C
• Electrical connection
Capacity: flexible: 0.5 to 1.5mm 2
Rigid: 0.5 to 2.5mm 2
• Dimensions: 130 x 60 x 27mm
This product can be used in EU
Declaration of Conformity : We hereby declare under our sole
responsibility that the products specified in these instructions
conform to the essential requirements of the EU R&TTE
Directive 1999/5/EC of March 1999.
The Quality Officer, BA Controls Hager Electro S.A.S., 33, rue
Saint-Nicolas 67704 Saverne Cedex / 09-02