MECHANICAL ASSEMBLY

More documents

Recommendations

Info

Press Fitting•Typical case is where a pin (e.g., a straight cylindricalpin) of a certain diameter is pressed into a hole of aslightly smaller diameter•Possible functions:Locating and locking components - to augmentthreaded fasteners by holding parts in fixedalignment with each otherPivot points - to permit rotation of one componentabout the otherShear pins©2002 John Wiley & Sons, Inc. M. P. Groover, “Fundamentals of Modern Manufacturing 2/e”
Shrink and Expansion FitsAssembly of two parts (e.g., shaft in collar) that have aninterference fit at room temperatureShrink fitting - external part is enlarged by heating,and internal part either stays at room temperature oris contracted by coolingExpansion fitting - internal part is contracted bycooling and inserted into mating component - whenat room temperature, expansion creates interference•Used to fit gears, pulleys, sleeves, and othercomponents onto solid and hollow shafts©2002 John Wiley & Sons, Inc. M. P. Groover, “Fundamentals of Modern Manufacturing 2/e”
Page 1 and 2: MECHANICAL ASSEMBLY•Threaded Fast
Page 3 and 4: Products of Mechanical Assembly•M
Page 5 and 6: Reasons Why Mechanical Assembly isO
Page 7 and 8: Screws, Bolts, and NutsScrew - exte
Page 9 and 10: Some Facts About Screws and Bolts
Page 11 and 12: Types of Screws•Greater variety t
Page 13 and 14: Self-Tapping Screws•Designed to f
Page 15 and 16: Figure 33.6 - Screw thread inserts:
Page 17 and 18: Figure 33.8 - Types of washers: (a)
Page 19 and 20: Figure 33.9 - Typical stresses acti
Page 21 and 22: Tools and Methods for ThreadedFaste
Page 23 and 24: RivetsUnthreaded, headed pin used t
Page 25 and 26: Rivets -Applications and Advantages
Page 27: Interference FitsAssembly methods b
Page 31 and 32: Figure 33.13 - Snap fit assembly, s
Page 33 and 34: Figure 33.14 - Retaining ring assem
Page 35 and 36: StaplingPreformed U-shaped staples
Page 37 and 38: Placement of a component into a mol
Page 39 and 40: Integral FastenersComponents are de
Page 41 and 42: SeamingEdges of two separate sheetm
Page 43 and 44: DFA Guidelines•Use modularity in

MECHANICAL ASSEMBLY

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?