Installing Dyna Coils - XJ4Ever

d) Now, back to the brackets. First up: removing the existing flasher relay mount, highlighted here in red.Leaving this in place is not an option; the new coils will bump up against it.Captain Obvious says, “Take the relay off the mountingbracket first!”There’s no set procedure for doing this, but onesuggestion might be to weaken the weld, then grab thebracket as close to the frame as possible with a crescentwrench and twist back and forth. Either way, get asmuch as you can off,THEN GRIND THE REST FLUSH.If you don’t, depending on which model you have, thebump might still get in the way of the coil.Once that’s done, prep the area, take your trusty can of X-Act Match paint, and make it look all nice and purdy.11