INSTALLATION TOOLING Grip Gauge Slide
INSTALLATION TOOLING Grip Gauge Slide
INSTALLATION TOOLING Grip Gauge Slide
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>Grip</strong> <strong>Gauge</strong> <strong>Slide</strong>2-651<strong>Grip</strong> Scale and<strong>Slide</strong> AssemblyIncludes 2-612 <strong>Grip</strong> Scale and 2-615 <strong>Grip</strong> <strong>Gauge</strong> <strong>Slide</strong>.NEW SLIDE2-615<strong>Grip</strong> <strong>Gauge</strong> <strong>Slide</strong>Will fit all existing Hi-Shear Corporation 2-612 <strong>Grip</strong> Scalesas shown below.2-612<strong>Grip</strong> ScaleThe original and best instrument for measuring both hole depth andfastener grip. The scale is spring temper stainless steel and 3/4” x 6-1/4” in size. The finish is satin with red and black lettering.Scale for measuring depth of hole. Graduated in 1/16” increments to 3”.Scale for measuring grip length of fasteners graduated in1/16” increments to 3”.Fastener MeasurementTo measure fastener grip length, place fastener against gripscale as shown. Read highest number opposite last point offull shank diameter.GRIPLENGTHGRIPLENGTHMeasuring a -6 grip lengthcountersunk head pin.Measuring a -7 grip lengthprotruding head pin.7102rev —HS <strong>TOOLING</strong>14083 S. Normandie Ave, Gardena CA 90249 USA800.482.4167 • fax 310.464.8545GRIP GAUGE SLIDE
<strong>INSTALLATION</strong> <strong>TOOLING</strong><strong>Grip</strong> Scale 2-6121/16" Increments to 3"1mm Increments to 75mmTo save shop time for riveters and inspectors, <strong>Grip</strong> Scales measurethe grip length of countersunk and flathead HI-SHEAR pins and workthickness or rivet hole depths in increments corresponding to the HI-SHEAR dash number system of pin grip lengths.The Scale is 0.020 spring temper stainless steel and 3/4” x 6-1/4” insize. The finish is satin with red and black lettering.SCALE FOR MEASURING DEPTH OF HOLE. GRADU-ATED IN 1/16” INCREMENTS TO 3”.SCALE FOR MEASURING GRIP LENGTH OF FASTENERS.GRADUATED IN 1/16” INCREMENTS TO 3”.SCALE FOR MEASURING DEPTH OF HOLE.GRADUATED IN MILLIMETER INCREMENTS TO7-1/2 CENTIMETERS.SCALE FOR MEASURING GRIP LENGTH OF FASTENERS. GRADUATEDIN MILLIMETER INCREMENTS TO 7-1/2 CENTIMETERS.TO MEASURE HOLE DEPTH, HOOK ON BOTTOM OF HOLE. READHIGHEST NUMBER EVEN WITH STRUCTURE ON OTHER END.TO MEASURE FASTENER GRIP LENGTH, PLEASE FASTENER AGAINSTGAGE AS SHOWN. READ HIGHEST NUMBER OPPOSITE LAST POINT OFFULL SHANK DIAMETER.GRIPLENGTHMEASURING A -7 GRIPLENGTH PROTRUDINGHEAD PIN.MEASURING A -6 HOLE(6/16" OR 3/8")GRIPLENGTHMEASURING A -6 GRIPLENGTH COUNTERSUNKHEAD PIN.MEASURING A -7 HOLE(7/16")GRIP SCALE 2-6121/16" INCREMENTS TO 3" 1MM INCREMENTS TO 75MM7103rev —
Change language