PDF Kabuki System Manual - Rose Brand

More documents

Recommendations

Info

$Cleaning Instructions For ROSE BRAND\'S Tendo Fabric$

Tools Needed: 7/16” Wrench or Adjustable Wrench3/16” Allen Wrench (included with Trip Mechanism)1/8” Allen Wrench (included with Trip Mechanism)Materials Recommended: Tie-LineEnd PlatePipe ClampAnd BracketCouplingTrip MechanismSupport RodCurtain RodCurtain PinLeverFigure 1: Kabuki units with and without a Trip Mechanism installed.ROSE BRAND NJ 800.223.1624 CA 800.360.5056
Step 1: Layout all Kabuki units on the floor below batten pipe or truss. Units with trip mechanisms indicated bya plastic cover go on the ends with the plastic cover facing off-stage (If trip mechanisms are not installed, seeTrip Mechanism instructions). Loosen thumb screws on all pipe clamps completely. You may also need toloosen the pipe clamp bracket nuts slightly (just enough so they slide) using a 7/16” wrench.Pipe Clamp Thumb ScrewPipe Clamp Bracket NutsFigure 2Step 2: Starting from the center of the batten pipe or truss, hang one Kabuki unit (aligned with center) andtighten the pipe clamp thumb screws and bracket bolts.Step 3: Hang another Kabuki unit adjacent to the first and tighten the pipe clamp thumb screws only.ROSE BRAND NJ 800.223.1624 CA 800.360.5056
Page 1: Installation InstructionsVersion 1.
Page 5 and 6: Step 7: Rotate curtain rods so the
Page 7 and 8: Install Trip MechanismIncluded with

PDF Kabuki System Manual - Rose Brand

Create successful ePaper yourself

Delete template?

Save as template?