MSDS - Regal Plastics

9. SPILL OR LEAK PROCEDURESMATERIAL SAFETY DATA SHEETSMP 54750 RESIN PART ASPILLS:Contain and remove with absorbent material. Avoid contact.WASTE DISPOSAL METHOD: Disposal should be done in accordance with Federal (40CFR Part 261), State and local regulations. Beforeattempting clean-up, refer to hazard caution information inother sections of the MSDS form. Use only licensedhazardous waste disposal companies.10. SPECIAL PRECAUTIONSHANDLING AND STORAGE:OTHER:11. TRANSPORTATION INFORMATIONDOT PROPER SHIPPING NAME:HAZARD CLASS OR DIVISION:PACKING GROUP NUMBER:REQUIRED LABEL:Do not store near heat or open flame.Empty container should not be reused.NOT REGULATEDNANANONEPage 3 of 3

RevisedJanuary 2002EMERGENCY PHONE 1-800-255-39249411 Corsair RoadFrankfort, IL 604231-800-552-0299 Phone1-815-464-5650 FaxMATERIAL SAFETY DATA SHEETSMP 54750 PART BHMIS; HEALTH 3 FLAMMABILITY 1 REACTIVITY 0NFPA HEALTH 3 FIRE HAZARD 1 REACTIVITY 01. GENERAL INFORMATIONPRODUCT NAME:CHEMIC AL FAMILY:CHEMICAL NAME:MP 54750 - PART BPOLYAMINE BLENDMixture2. COMPOSITIONINGREDIENT: CAS# OSHA PEL ACIGH TLVPOLYAMIDE RESIN* NA NA NA* EXACT IDENTITY WITHHELD AS A TRADE SECRET3. PHYSICAL DATAFLASH POINT (PMCC) :>200 o FBOILING POINT:DecomposesVAPOR DENSITY:> AIREVAPORATION RATE:NIL% VOLATILE BY VOL.: 0SPECIFIC GRAVITY: .98SOLUBILITY IN WATER:SLIGHTVAPOR PRESSURE:< 1mm HgAPPEARANCE AND ODOR:AMBER LIQUID, MILD AMINE ODOR4. FIRE AND EXPLOSION HAZARD DATAFLASH POINT:EXTINGUISHING MEDIA:SPECIAL FIRE FIGHTING PROCEDURES:UNUSUAL FIRE & EXPLOSION HAZARDS:>200°F (method used PMCC)Water fog, carbon dioxide, foam or dry chemical.Full protective equipment including self-contained breathingapparatus should be used. Water spray may be used to coolfire exposed container to prevent pressure build-up andpossible auto-ignition or rupture.Keep containers tightly closed. Water may be used to coolunruptured containers.5. HEALTH HAZARD DATAEye ProtectionSkin ContactInhalationIngestion6. REACTIVITY DATASTABILITY:CONDITIONS TO AVOID:MATERIALS TO AVOID:HAZARDOUS POLYMERIZATION:Page 1 of 2Flush eyes with water for at least 15 minutes. Take to aphysician for medical treatment.Wash affected areas with soap and water. Removecontaminated clothing. Consult a physician ifirritation persists.Move person to fresh air. Restore breathing. Treatsymptomatically. Consult a physician.Drink plenty of water to dilute. Do not induce vomiting.Give medical attention immediately. Never give anythingby mouth to an unconscious person.StableHigh temperatures, high humidity.STRONG OXIDIZING AGENTS, ACIDS, EPOXY RESINSIN UNCONTROLLED CONDITIONSWill not occur