engineering standard for process flow diagram

More documents

Recommendations

Info

IPS-E-PR-170Note:- There is no distinction between "Single" or "Multiple" stage.- Drivers need not be shown.12.9 Compressor, Expander and Blower Symbolsa) Centrifugal Compressor b) Reciprocating Compressorc) Expander d) BlowerCompressor Turbinee) Driver ControlCOMPRESSOR, EXPANDER AND BLOWER SYMBOLSFig. 1.1123
IPS-E-PR-170Notes:- There is no distinction between "Single" or "Multiple" stage.- The intercooler need not be shown.- The driver need not normally be shown.- In the case where the process gas pressure or flow rate is controlled by a driver (speed), it is necessary to show the driverand control system as mentioned above.12.10 Column Symbolsa) Tray Column b) Swaged Column c) Packed Column d) Rotating DiscContactorCOLUMN SYMBOLSNotes:- Skirts and supports need not be shown.Fig. 1.12- The trays should be shown pictorially in such a way that their number can be readily determined. Actual numbers should beinserted only in parts which are important from the process point of view.- Special trays such as draw offs, feed trays and those which locate process lines and/or instruments shall be shown.- Packed beds should be shown pictorially in such a way that their number can be readily determined.24
Page 1 and 2: IPS-E-PR-170ENGINEERING STANDARDFOR
Page 3 and 4: IPS-E-PR-1708.2.1 Designated stream
Page 5 and 6: IPS-E-PR-1700. INTRODUCTIONThe Stan
Page 7 and 8: IPS-E-PR-170b) Scope of processPFD
Page 9 and 10: IPS-E-PR-170a) Main process linesTh
Page 11 and 12: IPS-E-PR-1706.10 Base LineAs a rule
Page 13 and 14: IPS-E-PR-1708.2.6 Drumsa) Identific
Page 15 and 16: IPS-E-PR-170c) Valves associated wi
Page 17 and 18: IPS-E-PR-17011. HEAT AND MATERIAL B
Page 19 and 20: IPS-E-PR-17012.1.1 Piping-Pipelines
Page 21 and 22: IPS-E-PR-17012.2 Shell and Tube Typ
Page 23: IPS-E-PR-170Note:- Where temperatur
Page 27 and 28: IPS-E-PR-17012.12 Reactor SymbolREA
Page 29 and 30: IPS-E-PR-17012.15 Other Equipment S
Page 31: IPS-E-PR-170APPENDICESAPPENDIX AA T

engineering standard for process flow diagram

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?