Gunsmith Series - GT Bullet Trap - Savage Range Systems

Savage Range Systems, Inc.Model GTWARNINGSClose proximity shooting is by nature dangerous and we recommend the User wearproper Personal Protective Equipment (PPE) – gloves, face shields, hearing protection,etc. - when using or maintaining the Snail Trap.Certain types of bullets may result in fragments being emitted from the trap.Wash hands after each use or maintenance procedure.III.INSTALLATION & STARTUPINSTALLATION PROCESS1. Unpack unit to verify that all components are accounted for as listed on the packing slip.The bullet collection tray and oil are shipped inside the unit.2. Place the trap in a safe, well-ventilated location.3. Insert the bullet collection tray into the trap, pushing it all the way to the rear.4. Add approximately 5-gallons fresh, clean water to the trap. The water level should beabout 1” below the bottom of the door opening.5. Add 1-1/2 cups Snail Oil to the tank. The ideal concentration is 2 – 3% oil / water. A usefulguide is 1/2 cup of oil per gallon of water.6. Secure the door.7. The vent on the Model GT can be connected to a wet/dry shop vacuum, if desired.IV.OPERATION & MAINTENANCEOPERATIONWARNING – Do not exceed the ammunition rating for the Snail Trap.WARNING – Ensure that the operator is wearing proper hand, face and ear protection.Place muzzle of the firearm into the shooting port. Barrel should be horizontal to the floor andcentered in the shooting port. Improper barrel alignment will cause premature wear of theSnail Trap and could cause injury to the User.NOTICE –The firing of any gun may cause liquid to splash onto the barrel. This is notharmful to the firearm as the liquid has an oil base. Simply wipe off with a dry cloth.ROUTINE & PREVENTIVE MAINTENANCEDailyCheck water level in trap. Top us with clean water as necessary.Check level of spent bullets in the tray. Using the hook provided, slide the tray out of theunit. Dispose of the spent rounds in the proper recycling container.Ensure that access door is tight. The vibrations from rounds striking the trap can loosenthe bolt.100 Springdale Road Operation & Maintenance Manual Page 4 of 5Westfield, MA 01085Gunsmith Series800-370-0712

Savage Range Systems, Inc.Model GTWeeklyCheck Snail Oil concentration using a refractometer. Oil concentration should be between2% & 3%. Add oil as necessary.Inspect the trap for signs of damage or excessive wear. If any damage is noted, stop use ofthe trap and call Savage Range Systems 800.370.0712 immediately and speak to RangeProduct Support.Using a metal scoop, remove any sludge build-up on the bottom of the trap and place is theproper container for either recycling or disposal.V. REPLACEMENT OF PARTS / COMPONENTSReplacement or repair of parts can be ordered directly from Savage Range Systems, Inc. Call800.370.0712, Range Product Support, for assistance or visit our Website atwww.savagerangesystems.com.Item Part No. Manufacturer / SupplierBullet Collection TraySavage Range SystemsSafety Cover – 3” black 710015 Savage Range SystemsSnail Oil1-pint 1911401-quart 0301581-gallon 1911605-gallon 191170Savage Range SystemsDeleading Handwash 501022 Savage Range SystemsRefractometer 190121VI.MANUFACTURER’S LITERATURESnail Oil (MSDS)100 Springdale Road Operation & Maintenance Manual Page 5 of 5Westfield, MA 01085Gunsmith Series800-370-0712