2006 - Dirt Jumper I

© Marzocchi Suspension2006 - Dirt Jumper IRemove the complete valve groupe (4) from the pumping element.Remove the preload tube (9) (only on models with 110mm travel).Remove the rebound spring (7).If the piston segment (8) is damaged, you can prize it off with a small flat-tip screwdriver.Dismantling: Removing the sealsPrize the dust seal (1) off its seat with a small flat-tip screwdriver.Take great care not to damage the internal surfaces of the one-piece assembly whileremoving the dust seal.With the same screwdriver, prize off the metal stop ring (2).Take great care not to damage the internal surfaces of the one-piece assembly whileremoving the stop ring.Protect the upper part of the slider with the special tool (A).With a screwdriver, prize off the sealing ring (3).Remove the sealing ring (3).Take great care not to damage the internal surfaces of the one-piece assembly whileremoving the sealing ring.