2006 - 66 VF

© Marzocchi Suspension2006 - 66 VFUsing a hammer, knock in introducer (A) and drive the sealing ring home into the arch-slider assembly.Using a small flat-tip screwdriver, fit the stop ring (2) and check that it fits perfectly into its groove.Take great care not to damage the internal surfaces of the one-piece assembly when fittingthe stop ring.The dust seals shall be refitted when reassembling the crown-stanchion unit / arch-slider assembly.Assembling: Assembling the right pumping element and valveReplace the segment (8) of the pumping element, if necessary.Insert the rebound spring (6) and the preload tube (5) (only on models with 150mm travel) into thepiston rod.Assemble the valve unit in this order: bushing (4),valve (5), conical spring (11), three-point ring (6), andcheck that the parts are oriented as shown.Insert the pre-assembled valve in the piston rod from the three-point ring side as shown.Insert the valve and the pumping element (3) into the stanchion.