Specs - Heavy Equipment Rental

T140 COMPACT TRACK LOADER SPECIFICATIONSDIMENSIONSA) Operating Height .................................... 143.5" (3645 mm)B) Height with Operator Cab ...................... 77.4" (1967 mm)C) Angle of Departure ................................. 30°D) Ground Contact Length .......................... 48.4" (1230 mm)E) Length without Attachment ..................... 95.8" (2432 mm)F) Length with Standard Bucket ................. 124.1" (3153 mm)G) Rollback @ Ground Position ................. 25°H) Dump Height with Standard Bucket ....... 82.8" (2104 mm)I) Height to Bucket Hinge Pin .................... 109.6" (2783 mm)J) Dump Reach @ Maximum Height ......... 25.6" (649 mm)K) Dump Angle @ Maximum Height ........... 40°L) Rollback Fully Raised@ Maximum Height .............................. 96°Carry Position ............................................... 9.2" (233 mm)Ground Clearance ........................................ 7.8" (197 mm)M) Width over Bucket56" Bucket .................................. 56.0" (1422 mm)N) Turning Radiuswith Standard Bucket ............... 77.2" (1960 mm)Rear Clearance of Machine ..... 56.5" (1434 mm)O) Track Tread11.8 in. tracks ............................. 43.2" (1097 mm)P) Width (over tracks)11.8 in. tracks............................ 55.0" (1397 mm)PERFORMANCERated Operating Capacity (SAE J732 - no more than 35% of Tipping Load)........................... 1400 lbs. (635 kg)Operating Capacity (no more than 50% of Tipping Load) ......................................................... 2022 lbs. (917 kg)Tipping Load (SAE).................................................................................................................. 4044 lbs. (1834 kg)Operating Weight (SAE) .......................................................................................................... 6660 lbs. (3021 kg)Travel Speed........................................................................................................................... 7.3 mph (11,8 km/hr)Lift Breakout Force (SAE) ....................................................................................................... 2650 lbs. (1202 kg)Tilt Breakout Force (SAE) ....................................................................................................... 3500 lbs. (1588 kg)Push Force .......................................................................................................................... 4500 ft.-lbs. (2041 kg)*Rated operating capacity (ROC) @ 35% of Tipping Load complies with ISO 14397-1 and SAE J 818 for crawler loaders.

Bobcat T140 Compact Track Loader Specifications March 11, 2008ENGINE/ELECTRICALMake/Model .................................... Kubota/V2403-MDI-E3Fuel/Cooling .................................... Diesel/LiquidHorsepower (SAE Gross) ............... 49 HP (36 kW)Maximum Governed RPM ............... 2700 RPMTorque @ 1650 RPM (SAE Net) ..... 109.6 ft–lbs. (148,60 Nm)Number of Cylinders ....................... 4Displacement .................................. 148.5 cu. in. (2,4 L)Bore/Stroke ..................................... 3.43 / 4.03 in. (87 / 102 mm)Fuel Consumption ........................... 1.8 gph (6,8 L/h)Estimated fuel consumption is based on testing byBobcat Company in high duty cycle digging applications.Lubrication ...................................... Pressure System with FilterCrankcase Ventilation..................... Closed BreathingAir Cleaner ...................................... Dry replaceable cartridge with safety elementIgnition............................................. Diesel-CompressionEngine Coolant ............................... Propylene glycol/water mix (53%-47%) with freeze protectionto -34°F (-37°C)Starting Aid ..................................... Glow plugsAlternator ........................................ Belt driven; 90 amps; VentilatedBattery ............................................ 12 volt; 600 cold cranking amps @ 0°F(-18°C);115 minute reserve capacityStarter ............................................. 12 volt, gear reduction type; 4.02 HP (3,0 kW)HYDRAULIC SYSTEMPump Type .............................................. Engine Driven, gear typePump Capacity, Standard Flow .............. 16.9 GPM (64,0 L/min) @ 3135 RPMSystem Relief @ Quick Couplers........... 2650 - 2750 PSI (183 - 189 Bar)Hydraulic Filter ....................................... Full flow replaceable, Number 3 micron synthetic media elementHydraulic Cylinders................................. Double-acting; tilt cylinders have cushioning feature on dumpand rollbackControl Valve ........................................... 3-Spool, open center type with float detent on lift and electricallycontrolled auxiliary spoolFluid Type ................................................ Bobcat Hydraulic/Hydrostatic Fluid (P/N 6563328)Motor oil is not an acceptable alternative fluid.Bore DiameterLift Cylinder (2) ................................. 2.00 in. (50,8 mm)Tilt Cylinder (1) ................................. 3.50 in. (88,9 mm)Rod DiameterLift Cylinder (2) ................................. 1.25 in. (31,8 mm)Tilt Cylinder (1) ................................. 1.50 in. (38,1 mm)StrokeLift Cylinder (2) ................................. 26.57 in. (674,9 mm)Tilt Cylinder (1) ................................. 14.50 in. (368,3 mm)Hydraulic Function TimesRaise Lift Arms ................................. 2.6 Seconds Bucket Dump ......................... 2.2 SecondsLower Lift Arms................................. 1.8 Seconds Bucket Rollback..................... 1.8 Seconds

Bobcat T140 Compact Track Loader Specifications March 11, 2008DRIVE SYSTEMMain Drive .................Fully hydrostatic, rubber track driveTransmission ............Infinitely variable tandem hydrostatic piston pumps,driving two fully reversing hydrostatic motorsTracks .......................11.8 in. width (300 mm)Tension-grease cylinder and spring rollers–triple flangeGROUND PRESSUREGround Pressure.......5 PSI (34,5 kPa)CAPACITIESFuel Tank .................................... 15.4 gals. (50,4 L)Cooling System ............................ 12.0 qts. (11,4 L)Engine Oil with Filter........................ 9.5 qts. (9,0 L)Hydraulic/Hydrostatic Reservoir... 3.5 gals. (13,3 L)Hydraulic/Hydrostatic System .......6.0 gals. (22,7L)CONTROLSVehicle Steering ........................Direction and speed controlled by two hand leversLoader HydraulicsLift & Tilt ..............................Controlled by separate foot pedals or optional Advanced Control System (ACS)Front Auxiliary (Std.) ..........Controlled by electrical switch on Right Hand steering leverRear Auxiliary (Opt.) ..........Controlled by electrical switch on Left Hand steering leverAuxiliary Pressure Release ......Pressure is relieved through the coupler block, push in and hold for five secondsEngine .......................................Hand lever throttle; key-type starter switch and shutdownStarting Aid ...............................Glow Plugs – automatically activated by Standard or Deluxe Instrument PanelService Brake............................Two independent hydrostatic systems controlled by two hand operatedsteering leversSecondary Brake ......................One of the hydrostatic transmissionsParking Brake ............................Finger-operated rocker switch on center control panel withspring applied, pressure release multi disk brakeSERVICEABILITYAccess is available to the following through the rear door/tailgate and rear screenAir cleanerAlternatorBatteryCooling system (radiator and hydraulic oil cooler) for cleaningEngine oil and fuel filtersEngine oil drain and dipstickFuel fillHydraulic oil fillStarterBobtach pivots have replaceable wear bushingsEasy access to all lift arm grease pointsRod end of the tilt cylinder has a replaceable bushingTailgate has an optional lock for vandal proofingTailgate is equipped with door stop to hold door open while servicingTip-up operator cab gives access to certain hydraulic system components

Bobcat T140 Compact Track Loader Specifications March 11, 2008INSTRUMENTATIONThe following loader functions are monitored by a combination of gauges and warning lights in the operator’sline of sight. The system alerts the operator of monitored loader malfunctions by way of an audible alarm andvisual warning lights.Standard Instrument PanelGaugesEngine Coolant TemperatureFuelHourmeterIndicatorsAttachment Control DeviceBICS FunctionsGlow PlugsWarning LightsAdvanced Control System (ACS)Engine Air FilterEngine Coolant TemperatureEngine Oil PressureFuel LevelGeneral WarningHydraulic FilterHydraulic Oil TemperatureHydrostatic Charge PressureSeat BeltSystem VoltageDeluxe Instrument Panel (Option)Same gauges, warning lights and other features as Standard Instrument Panel plus:Bar-type gauges:........................................Engine Oil Pressure, System Voltage, Hydrostatic Charge Pressureand Hydraulic Oil TemperatureAdditional features: ....................................Keyless Start with password capability, Digital Clock, Job Clock,Attachments Information, Digital Tachometer, Help Screens,High Flow Lockouts (if applicable), Multi-Language Display, DiagnosticCapability and Engine/Hydraulic Systems Shutdown FunctionATTACHMENTSAngle Broom*AugerBackhoeBale ForksBox BladeBox Blade with Laser*Brush SawBrushcat Rotary CutterBucketsChipper*Combination BucketConcrete MixerDiggerDozer Blade*Dumping HopperGrader*Grapple, Farm/UtilityGrapple, IndustrialHydraulic BreakerLandplaneLandscape RakeMowerPallet Fork - StandardPallet Fork - Hydraulic* Requires Attachment Control KitFor specific model availability - See Bobcat Product Price List.PlanerRear StabilizerScarifierScraperSeederSnow BladeSnow V-Blade*Snowblower*Sod LayerSoil ConditionerSpreaderSweeperThree-Point HitchTillerTilt-TatchTree SpadeTrench CompactorTrencherUtility ForksVibratory RollerWater KitWhisker Broom

Bobcat T140 Compact Track Loader Specifications March 11, 2008FACTORY OPTIONSAdvanced Control System (ACS)Selectable Joystick Control (SJC)Back-up Alarm and HornEngine Block HeaterHydraulic Bucket PositioningDEALER ACCESSORIESAttachment Control KitBack-up AlarmCab Accessory HarnessCab EnclosureCatalytic Exhaust PurifierFire Extinguisher KitFOPS Kit - Level II**Four-point Lift KitFour-Way Flasher Light KitHornHydraulic Bucket PositioningLocking Fuel CapPower Bob-TachRadioRear Auxiliary HydraulicsRotating Beacon LightSide Windows KitSingle-point Lift KitSpecial Applications KitStrobe Light KitTailgate Lock KitHEATED CAB PACKAGESH71 Option PackageCab Enclosure with HeatPower BobtachSound ReductionDeluxe Instrumentation PanelCab Accessory HarnessAttachment Control KitH51 Option PackageCab Enclosure with HeatPower BobtachCab Accessory HarnessH31 Option PackageCab Enclosure with HeatCab Accessory HarnessOPEN CAB PACKAGESO71 Option PackagePower BobtachDeluxe Instrumentation PanelCab Accessory HarnessAttachment Control KitO51 Option PackageDeluxe Instrumentation PanelCab Accessory Harness

Bobcat T140 Compact Track Loader Specifications March 11, 2008SAFETYBobcat Interlock Control System(BICS) (Std.) ............................................. Requires the operator to be seated in the loader with theseatbar in place and the engine running. After the operator pressesthe “Press to Operate Loader” button, the loader’s hydraulic lift and tiltfunctions and traction drive system can be operated.Lift Arm Bypass Control (Std.) .................Used to lower the lift arms in the event that the lift arms cannotbe lowered during normal operating conditionsSeat Belt (Std.).........................................Should always be worn when operating the loaderSeat Bar (Std.) .........................................Secondary operator restraint, also serves as an arm restOperator Cab (Std.) .................................. An enclosable operator cab with side screens with a minimalinside cab width of 33" (838 mm) as standard equipment.Meets SAE J1040 and ISO 3471 for Roll Over Protective Structure(ROPS) and SAE J1043 and ISO 3449 Level I for Falling ObjectProtective Structure (FOPS). Level II option is available.Level I – Acceptance is intended for protection from falling bricks, small concrete blocks and hand toolsencountered in operations such as highway maintenance, landscaping and other construction site services.Level II – Acceptance is intended for protection from falling trees or rocks for machines involved in site clearing,overhead demolition or forestry.Lift Arm Support (Std.) ................................ Use for servicing when lift arms are raisedParking Brake (Std.) .................................... Always set brake when leaving loaderGrab Handles (Std.) ..................................... Should always be used when entering/exiting loaderSafety Tread (Std.) ...................................... Slip resistant tread on lift arms and main frame to be usedwhen entering/exiting loaderAttachment Steps (Std.) ............................. Should always be used when entering/exiting loaderRear Window (Std.) ..................................... For emergency exitFront & Rear Working Lights (Std.) ............ Use for indoor and low light operationBackup Alarm (Opt.).................................... For use in jobs with low visibilityLift Kits (Opt.) .............................................. Lift kits are available so loader may be lifted into remote areasSpecial Applications Kit (Opt.).................... Restricts objects and material from entering cab openingsOperator’s Handbook (Std.) ......................... Weather resistant operator handbook written in English will beattached to inside of cab, providing operational instructions andwarnings by decals with pictorials and international symbols plussome messages in four basic languages: English, French, Germanand Spanish.TRAINING RESOURCESThese optional videotapes and training courses are available through Bobcat PartsBobcat Skid-Steer Loader Operator Training Course4-hour course provides video, classroom and hands-on training (also available in Spanish)Bobcat Skid-Steer Loader Service Safety Training Course2-hour course provides video, classroom and hands-on trainingBobcat Skid-Steer Loader Safety VideoShort and to-the-point video provides basic safety instructions for the Skid-Steer Loader