MATERIAL SAFETY DATA SHEET Revision: - Sievert AB

More documents

Recommendations

Info

SIEVERT ABMATERIAL SAFETY DATA SHEET Revision: 1.1ULTRAMAPP GAS220683, 220684Date: 08/12/20103. COMPOSITION/INFORMATION ON INGREDIENTSIngredient EC-no CAS-no Weight % ClassificationPropylene 204-062-1 115-07-1 50-100 H 220 / F+, R12Isobutane 200-857-2 75-28-5 10-25 H 220 / F+, R124. FIRST-AID MEASURESInhalation:Skin contact:Eye contact:Ingestion:Supply fresh air, consult doctor in case of complaints.Generally the product does not irritate the skin. If frostbite occur, flush with lukewarm(20-30°C) water. DO NOT USE HOT WATER. Contact doctor.Rinse opened eye for 15 minutes under running luke warm (20-30°C) water.Contact doctor if any symptoms remain.If symptoms persist consult doctor.5. FIRE-FIGHTING MEASURESExtinguishing mediaSuitable extinguishingagents:Unsuitable extinguishingagents:Hazardous combustionproducts:Advice for firefighters:CO2, sand, extinguishing powder. Do not use water.Water, water with fully jet.Creates explosive mixture with air.No special measures required.6. ACCIDENTAL RELEASE MEASURESPersonal precautions:Environmental precautions:Methods and material forcontainment and cleaning up:Wear protective equipment. Keep unprotected persons away. Keep ignition sourcesaway.No special measures required.Ensure good ventilation. Do not flush with water or aqueous cleansing agents.7. HANDLING AND STORAGEInformation for safe handling:Information about fire -and explosion protection:Requirements to be met bystorerooms and receptacles:Information about storagein one common storagefacility:Ensure good ventilation/exhaustion at the workplace.Open and handle receptacle with care.Keep ignition sources away – Do not smoke.Protect against electrostatic charges.Pressurized container, protect from sunlight and do not expose to temperaturesexceeding 50°C. Do not pierce or burn, even after use. Do not spray onto a nakedflame or any incandescent material.Store in a cool and well-ventilated location.Observe official regulations on storing packaging with pressurized container.Not required.Further information aboutstorage conditions:Class according to regulationon flammable liquids:Keep receptacle tightly sealed. Store in cool, dry condition.Protect from heat and direct sunlight.Void.Page 2 of 4 Print date: 16/11/2012
SIEVERT ABMATERIAL SAFETY DATA SHEET Revision: 1.1ULTRAMAPP GAS220683, 220684Date: 08/12/20108. EXPOSURE CONTROLSAppropriate engineeringcontrols:Personal protectionequipment:Environmental exposurecontrols:No further data, see item 7.Make sure that it is well ventilation. Do not smoke during handling.No further data, see item 7.9. PHYSICAL AND CHEMICAL PROPERTIESForm: Compressed liquefied gas. Vapour pressure: Approx. 9 bar at 20°CColour: Colourless. Gas density: Heavier than air.Odour: Sweetish Boiling point: Approx. -47°C.Density: Approx. 0,6 g/cm3 at 20°C. Ignition temperature: 455°CUpper explosion risk limit: 11,1% by volume in air. Self ignition: Product is not self-igniting.Lower explosion risk limit: 1,8% by volume in air. Solubility in water/grease: Slightly insoluble10. STABILITY AND REACTIVITYPossibility of hazardousreactions:Conditions to be avoided:Hazardous decompositionproducts:No dangerous reactions known.No decomposition if used according to specifications.No dangerous decomposition products known.11. TOXICOLOGICAL INFORMATIONInformation on toxicological effectsRisks at inhalation:Risks at contact:Propylene is a gas slightly narcotic and may in highly concentrated form irritate mucousmembranes and cause suffocation. The suffocation effect is proportional to the decrease ofthe partial pressure of the oxygen in the inhalation air obtained at a mixture of propylene andair. When the oxygen content has decreased to three fourths or less of the normal contentasphyxia occurs. The body interprets this as a lack of oxygen and reacts (at concentrations of50 vol.-% propylene in air) with pronounced symptoms of suffocation in the form of difficulty tobreath and hyperventilation simultaneously with deteriorated reaction ability and impairedmuscle co-ordination. More serious cases (at concentrations of 75 vol.-% propylene in air)may end in unconsciousness and death.Propylene in liquefied or gaseous form may cause serious frostbites on skin or eyes. Ifpropylene in liquefied form gets into contact with objects of a higher temperature than theliquid itself it results in fierce boiling and splashing.12. ECOLOGICAL INFORMATIONEcological informationGeneral note:Generally not hazardous for water.13. DISPOSICAL CONSIDERATIONSWaste treatment methodsRecommendation:EWC code:Must not be disposed together with household garbage. Do not allow product to reach sewagesystem. Product to be deposited at suitable recirculation place, according to official regulations.16 05 00 – Gases in pressure containers and discarded chemicals.16 05 05 – Gases in pressure containers (including halons) containing dangerous substances.Page 3 of 4 Print date: 16/11/2012
Page 1: SIEVERT ABMATERIAL SAFETY DATA SHEE

MATERIAL SAFETY DATA SHEET Revision: - Sievert AB

Create successful ePaper yourself

Delete template?

Save as template?