Doc: ET 11(6562) LEAD ACID STORAGE BATTERIES FOR ... - BIS

More documents

Recommendations

Info

) The battery shall be maintained in this position for 3s;c) The battery shall be returned to the vertical position in a maximum period of 1s.6.8.3 Throughout the tests described in clause 6.8.2, the battery must be examined for any sign ofelectrolyte leaking from the battery. The observations shall be recorded.6.8.5 Requirement: See clause No 77 RequirementsThe requirements applicable to essential functional characteristics are summarized in Table 4 belowTable 4 - Summary of RequirementsFunctional Characteristics Requirements Comments20 h capacity ( 6.1 ) C e ≥C nFor batteries rated inAhReserve capacity ( 6.2 ) C r e ≥C r nFor batteries rated inReserve capacityCranking performance test ( 6.3 )- 18°C or - 29°C (If specified)U 10s ≥ 7.5 VU 30s ≥7.2 Vt 6 v ≥40 sTotal time ≥ 90s =(30/0.6 s + 40 s)CompulsoryCompulsoryOptionalCharge acceptance ( 6.4 ) I ca ≥2I oCharge retention ( 6.5 ) U 30s ≥ 8.0 VEndurance ( 6.6 )Corrosion test (6.6.1)Number of units = 4Cycling test 1 (6.6.2)Cycling test 2 (6.6.3)Number of cycles = 120Cycling test 3(40°C &Number of units = 575°C) (6.6.4)Number of cycles = 34*Cr,n - 581 aVibration (6.7) U 30s ≥7.2 VElectrolyte retention (6.8)No evidence of liquid on the vent plugs.Or higher if specifiedOr higher if specifiedOr higher if specifiedFor both C e or C r e and the cranking performance, the specified values shall be met in at least one of the threerelevant discharges above (see 6.1, 6.2, and 6.3)a) This formula applies for C r from 40 min to 150 min8 ADDITIONAL REQUIREMENTS FOR ECO MARK8.1.1 The automotive lead acid batteries shall meet the relevant standards of Bureau of IndianStandards8.1.2 The product manufacturer must produce the consent/ clearance as per the provisions of water(PCP) Act. 1974, Water(PCP) Cess Act, 1977 and Air (PCP) Act, 1981 along with the authorisationif required under environment (protection )act, 1986 and rules made thereunder.8.1.3 The product packing may display in brief the criteria based on which the product has beenlabelled environment friendly.8.1.4 The product may be sold along with instructions for proper use so as to maximize the product13
performance and safe disposal8.1.5 The material used for product packing shall be recyclable or biodegradable.8.1.6 The manufacturer shall organize the collections/payback system for the used batteries andprovide documentary evidence by way of certificate or declaration to this effect to bureau of IndianStandards while applying for ECO Mark.8.2 Product specific Requirements8.2.1 The quantity of lead used, in Kg per battery (A) charged battery weight with electrolyte in Kg(B) and ratio A:B shall not exceed the limits given below:Table under Consideration.8.2.2 Lead used in batteries shall be recovered/manufactured through a process complying underthe provisions of water ( PCP ) Act, 1974, water ( PCP ) Cess Act, 1977 and Air ( PCP ) Act, 1981along with the authorization if required under Environment ( Protection ) Act, 1986 and rules madethereunder.NOTE — The manufacturer of the battery shall obtain documentary evidence from the lead manufacturer tothis effect such as consent/clearance from pollution control board and provide the same to BIS whichapplying for ECO Mark.8.2.3 The manufacturer of ‘Oxide’ as well as ‘Grid’ plates of the battery shall ensure fullcompliance of the provision under water (PCP) Act, 1974, Water (PCP) Cess Act, 1977 and Air(PCP) Act, 1981 along with the authorisation if required under Environment ( Protection ) Act,1986 and rules made thereunder.NOTE — Manufacturer of the battery shall obtain documentary evidence from the ‘Oxide’ and ‘Grid’ manufacturers to this effect suchas consent/Clearance from pollution control board and provide the same to BIS while applying for ECO Mark.8.2.4 The product shall contain the following percentage of recycled lead ( from post-consumerlead ) measured over a period of 3 months ( as a rolling average ) where 100 percent is the totalamount of lead contained in the batteries manufactured during the quarter:a) Up to 1 Year 25 percent, Minimumb) Up to 2 Years 40 percent, Minimumc) Up to 3 Years 50 percent, MinimumNOTE — The manufacturer shall provide documentary evidence by way of certificate or declaration to this effect to bureau of IndianStandards while applying for ECO Mark.Annex A(normative)Correlation between C n and C r, nThe value of C r, n (in minutes) may be estimated from C n (in ampere hours) using the followingequation:14
Page 4 and 5: 3.1.1 Manufacturers name3.1.2 Class
Page 6 and 7: 5.2 Preparation of batteries prior
Page 8 and 9: C e 25°C = C eT [ 1 - 0.01(T - 25)
Page 10 and 11: 6.6.1 Corrosion test6.6.1.1.The tes
Page 12 and 13: with(forced) air circulation at a t
Page 16 and 17: C r, n = β (C n ) αWhereα = 1.12

Doc: ET 11(6562) LEAD ACID STORAGE BATTERIES FOR ... - BIS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?