Honda GL1800 Trailer Hitch Installation Instructions - Bushtec Trailers

More documents

Recommendations

Info

12Screw locations for rear panel removal.Screw under license plate on 2001 to2005 models only.Plastic cover over frame behind passenger board. Remove threescrews as highlighted to remove panel.With plastic cover removed, rear saddlebag boltsare exposed.Bolt securing subframe to main frame. Remove andreplace with provided bolts one side at at time.Left side- upper strut mount position. From rider positionlooking rearward. Bolt from outside through flat washer,Rear of motorcycle, behind rear fender panel aboverear tire. Black boot is location of plugs where12
13subframe, main frame, spacer, strut, washer, and nut.Isolator subharness is connected. Shown after install.(Revised 12/2009)13
Page 3 and 4: 3BUSHTEC PRODUCTS CORPORATION WILL
Page 5 and 6: 513. Remove the bolt securing the t
Page 7 and 8: 7WARNING: DO NOT OVER TIGHTEN THE J
Page 9 and 10: 9NOTE: DO NOT confuse the black wir
Page 11: 113. Remove the dead plug from the

Honda GL1800 Trailer Hitch Installation Instructions - Bushtec Trailers

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?