313 Curtain Wall - Ali Systems Limited
313 Curtain Wall - Ali Systems Limited
313 Curtain Wall - Ali Systems Limited
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Assembly and Installation<br />
Glazing of Frames<br />
When producing silicone glazing the actual glazing of the<br />
frames has to be carried out under factory conditions so<br />
that the sealants are given time to cure to produce a<br />
strong bond.<br />
Once the frame is constructed the double glaze panel can<br />
be installed.<br />
Apply the high bond glazing tape to the four sides of the<br />
frame as shown cutting the joints at 45º so that they<br />
match the mitred corners of the frame.<br />
Fit the double glaze unit into the frame with the larger<br />
pane to the outside ensuring that the frame is square and<br />
equally spaced around all four sides.<br />
Apply the black silicone sealant into the recess as shown<br />
below ensuring the sealant goes into the corners and<br />
completely fills the recess. This must be carried out<br />
around all four sides of each individual frame.<br />
Clean off any excess sealant from the frame and glass.<br />
Leave the frames to cure in accordance with the sealant<br />
manufacturers instructions before transporting to site.<br />
6-4<br />
NOTE: THIS OPERATION IS CARRIED OUT BY<br />
QUALIFIED STRUCTURAL SILICONE<br />
APPLICATORS ONLY.<br />
Silicone Glaze Frame<br />
©<br />
Norton High Bond<br />
Glazing Tape<br />
Sealant will be on this<br />
face of the glass when<br />
applied into the recess<br />
of section<br />
GLOSTAL. This data sheet is issued subject to the condition that<br />
it shall not be reproduced without the consent of Glostal in writing.<br />
Product Manual<br />
<strong>313</strong><br />
Structural Silicone<br />
Glazing<br />
04.97<br />
Double Glaze Unit, Fit square<br />
and apply sealant
Change language