Aerospace Tooling and Equipment

Aerospace Tooling and Equipment2.3 4/8 Indent Stripper Crimper with Touch Sensor SystemFast Facts• Modular open design• Fast and simple tool kit changes• Fast changeover times• Variety of tool kits• Touch sensor system• Wire sizes from 0.14 - 2.5 mm• Insulation diameter0.35 - 2.5 mm• Jacket strip length 30 mm• Strip length 2.0 - 10 mm• Electric power supply:115 V / 230 V• Compressed air: 500-700 kPa• Cycle time: 2.5 seconds• Weight: Approx. 60 kg• Dimensions machine [mm]W x H x D = 530 x 620 x 800The machine is suitable for strippingand crimping loose piececontacts to accepted MIL specificationswith 4/8 indent crimpform.The machine feeds, sorts andseparates the contacts prior tothe stripping an crimping process.A variety of contact specific toolkits is available or can be createdto suit almost all screw machinedcontacts.The machine is easy to operateand can be changed from onecontact to another quickly andeasily.The touch sensor is a safety systemdesigned to monitor when thestripping blades contact the conductorduring insulation stripping.If the blades make contact withthe conductor then the machinewill not crimp the contact.The system allows for partial or fullmonitoring or can be turned offcompletely.The touch sensor system is particularlyuseful when stripping wireswhere a non-contact situationis required.Application specific equipment:Please address your request toyour local Tyco Electronics representative.The relevant GATD contact can befound on the website below.For more detailed information please visit our websitewww.tooling.tycoelectronics.com/europe43