Electrak Pro - tollo linear ab, kristianstad, sweden
Electrak Pro - tollo linear ab, kristianstad, sweden
Electrak Pro - tollo linear ab, kristianstad, sweden
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
ELECTRAK PRO MARCH 2009 THOMSON<br />
Mounting<br />
Thomson <strong>Electrak</strong> <strong>Pro</strong> <strong>linear</strong> actuators are quickly and easily mounted by installing pins through the holes<br />
on each end of the unit and into customer mounting brackets on the machine frame.<br />
Note: Do not attempt to mount the <strong>Pro</strong>-Series actuator from its cover tube. The cover tube is not<br />
designed to support the forces required for mounting the actuator. Actuator damage or personal<br />
injury may result.<br />
Half inch (ø12,7mm) diameter solid pins provide maximum holding strength and a retaining or cotter pin on<br />
each end will prevent the solid pin from falling out of its mounting bracket. Roll or spring type mounting pins<br />
should be avoided. The mounting pins must be parallel to each other as shown in Figure 1. Pins that are not<br />
parallel to each other may cause the actuator to bind and lead to premature failure.<br />
The load should act along the stroke axis of the actuator since off center loads may cause binding and lead<br />
to premature failure. See Figure 2.<br />
8 DW110587GB-0910 EDITION 1 INSTALLATION MANUAL
Change language