INTERNATIONAL JOURNAL OF HEAT AND MASS TRANSFER - IWR

Yu. A. Buyevich, V. A. Ustinov
Volume (issue): 38 (1) 1995
Fully developed free convection in open-ended vertical concentric porous annuli 1 -- 12
M. A. Al-nimr
Modeling heat and mass transfer in fabrics 13 -- 21
K. Ghali, B. Jones, J. Tracy
The anisotropic overall thermal conductivity induced by preferentially oriented pores 23 -- 30
Da Yu Tzou
Effect of stress acting upon the solid network in the two-phase zone during solidification 31 -- 38
Q. Yu, M. Makhlouf, D. Apelian
An inverse analysis for estimating the time-varying inlet temperature in laminar flow
inside a parallel plate duct
J. C. Bokar, M. N. Ozisik
39 -- 45
Effect of modulation on radiation-induced instability 47 -- 53
Wen-Mei Yang
Computation of high-temperature near-wall heat transfer using an enthalpy balancing
scheme
P. J. Stuttaford, S. Anghaie, W. Shyy
Planar solidification of a finite slab: effects of the pressure dependence of the freezing
point
M. Conti
Exact solutions of Stefan problems for a heat front moving at constant velocity in a
quasi-steady state
C. K. Hsieh
Heat and mass transfer in the condensing flow of steam through an absorbing fibrous
medium
C. V. Le, N. G. Ly, R. Postle
Laser holographic interferometry study of developing heat transfer in a duct with a
detached rib array
Tong-Miin Liou, Wen-Bin Wang
Resolution d'un probleme inverse multidimensionnel de diffusion de la chaleur par la
methode des elements analytiques et par le principe de l'entropie maximale
Fernando M. Ramos, Andre Giovannini
55 -- 64
65 -- 70
71 -- 79
81 -- 89
91 -- 100
101 -- 111
Thermal convection in small enclosures: an atypical bifurcation sequence 113 -- 126
D. Mukutmoni, K. T. Yang
Experimental investigation of heat transfer in flat plates with rectangular
microchannels
X. F. Peng, B. X. Wang, G. P. Peterson, H. B. Ma
127 -- 137
Thermal stresses and heat-mass transfer in ablating composite materials 139 -- 146
Yu. I. Dimitrienko